Ads
related to: 5 major parts of airplane model
Search results
Results From The WOW.Com Content Network
Major components of a turbojet including references to turbofans, turboprops and turboshafts: Cold section: Air intake (inlet) — For subsonic aircraft, the inlet is a duct which is required to ensure smooth airflow into the engine despite air approaching the inlet from directions other than straight ahead. This occurs on the ground from cross ...
Singapore Airlines Boeing 747-400 scale display model Group of students with their wooden model airplanes in Sonta, Serbia, 1936. A model aircraft is a physical model of an existing or imagined aircraft, and is built typically for display, research, or amusement. Model aircraft are divided into two basic groups: flying and non-flying.
The main controls allow the pilot to direct the aircraft in the air by controlling the attitude (roll, pitch and yaw) and engine thrust. On manned aircraft, cockpit instruments provide information to the pilots, including flight data , engine output , navigation, communications and other aircraft systems that may be installed.
Advanced Supersonic Transport (AST) model in wind tunnel. The aircraft design process is a loosely defined method used to balance many competing and demanding requirements to produce an aircraft that is strong, lightweight, economical and can carry an adequate payload while being sufficiently reliable to safely fly for the design life of the aircraft.
This page was last edited on 29 September 2020, at 12:54 (UTC).; Text is available under the Creative Commons Attribution-ShareAlike 4.0 License; additional terms may apply.
Alloy 7075-T6 (70,000-psi yield strength), an Al-Zn-Mg-Cu alloy, was introduced in 1943. Since then, most aircraft structures have been specified in alloys of this type. The first aircraft designed in 7075-T6 was the Navy’s P2V patrol bomber. A higher-strength alloy in the same series, 7178-T6 (78,000-psi yield strength), was developed in ...