Search results
Results From The WOW.Com Content Network
1.0 long cwt (110 lb; 51 kg) short hundredweight: short cwt short cwt 1.0 short cwt (100 lb; 45 kg) long quarter: long qtr long qtr 1.0 long qtr (28 lb; 13 kg) short quarter: short qtr short qtr 1.0 short qtr (25 lb; 11 kg) stone: st st 14 lb used mostly in the British Commonwealth except Canada 1.0 st (14 lb; 6.4 kg) st kg. st kg lb; st lb
{{Convert}} uses unit-codes, which are similar to, but not necessarily exactly the same as, the usual written abbreviation for a given unit. These unit-codes are displayed in column 3 of the following tables. These are accepted as input by {{convert}} as the second and third unnamed parameters: {{convert|100|kg|lb}} → 100 kilograms (220 lb)
Units for other physical quantities are derived from this set as needed. In English Engineering Units, the pound-mass and the pound-force are distinct base units, and Newton's Second Law of Motion takes the form = where is the acceleration in ft/s 2 and g c = 32.174 lb·ft/(lbf·s 2).
Conversions between units in the metric system are defined by their prefixes (for example, 1 kilogram = 1000 grams, 1 milligram = 0.001 grams) and are thus not listed in this article. Exceptions are made if the unit is commonly known by another name (for example, 1 micron = 10 −6 metre).
There are four types of materials available: O-1 tool steel, A-2 tool steel, A-6 tool steel, and 1018 steel (low-carbon or low-carb steel). Lengths are either 18 or 36 in (457 or 914 mm) long, various widths up to 16 in (406 mm) are available, and thicknesses range from 1 ⁄ 64 to 2.875 in (0.40 to 73.03 mm).
1 pound per square inch (psi) ≈ 6,895 Pa; Torque 1 pound-foot ≈ 1.356 N⋅m; Insulation 1 R-value (ft 2 ⋅°F⋅h/Btu) ≈ 0.1761 R SI (K⋅m 2 /W) Various combination units are in common use; these are straightforwardly defined based on the above basic units. Sizing systems are used for various items in commerce, several of which are U.S ...
Conversion of units is the conversion of the unit of measurement in which a quantity is expressed, typically through a multiplicative conversion factor that changes the unit without changing the quantity. This is also often loosely taken to include replacement of a quantity with a corresponding quantity that describes the same physical property.
The conversion between different SI units for one and the same physical quantity is always through a power of ten. This is why the SI (and metric systems more generally) are called decimal systems of measurement units. [10] The grouping formed by a prefix symbol attached to a unit symbol (e.g. ' km ', ' cm ') constitutes a new inseparable unit ...