Ad
related to: jeep gear ratio explained chart
Search results
Results From The WOW.Com Content Network
The Jeep Cherokee (XJ) is a sport utility vehicle manufactured and marketed across a single generation by Jeep in the United States from 1983 (model year 1984) through 2001 — and globally through 2014. It was available in two- or four-door, five-passenger, front-engine, rear- or four-wheel drive configurations.
The 45RFE was introduced in the Jeep Grand Cherokee in 1999, it is notable for including three planetary gearsets rather than the two normally used in a 4-speed automatic. It also features three multiple disc input clutches, three multiple disc holding clutches, and a dual internal filter system (one primary filter for transmission sump, one for the fluid cooler return system).
The AX15 built by Aisin was used in Jeeps with the AMC 242 (4.0L) Inline 6 engine, as well as the AMC 258 (4.2L) Inline 6 engine and AMC (2.5L) Straight 4 engine.This included vehicles such as the Cherokee(XJ), Comanche (MJ), and Wrangler (YJ and TJ) and 1994-1995 Jeep Grand Cherokee ZJ as well as the 1st and 2nd generations of the Dodge Dakota.
26-tooth input gear, 1¼" intermediate shaft and 2.42:1 low range, 3" input hole; 29-tooth input gear, 1¼" intermediate shaft and 2.46:1 low range, 4" input hole, Dana 20 case; The normal (3") input Dana 18s are interchangeable, but the input gear must match the transfer case. The "big hole" (4" input) Dana 18 is transmission-interchangeable ...
The 9HP is only 0.24 inches (6 mm) longer than, and weighs 16.5 lbs (7.5 kg) less than, the outgoing six-speed transmission. The compact packaging is achieved by using a number of innovative design features: a new compact hydraulic vane-type pump, two patented dog clutches, [3] which replace bulkier conventional clutch packs, and a nested gear set. [2]
There were many ratios offered over the lifetime of the AMC 20. [1] Letter codes were stamped on the axle to indicate installed gears. AMC changed or reused letter codes during the axle's long life. There are other gear ratios available in the aftermarket.
A variation of the Dana 60 known as a Dana 61 was made to accommodate gear ratios that allowed for better fuel mileage. This was done as a direct result of the 1973 oil crisis. A 3.07:1 gear ratio was common for these axles and unachievable in a regular Dana 60. To allow for the different gearing, the Dana 61 had a greater pinion offset.
The Jeep Wrangler (JK) is the third ... rock rails, 32-spline rear axle with an 8.8-inch ring gear, 4.10 axle gearing, electric ... 4.10 front/rear axle ratio Tru-Lok ...