Search results
Results From The WOW.Com Content Network
Other than the piston rings, “blow-by” gases can push the fuel oil past the rings and into the crankcase. [1] “Blow-by” gases are a mix of fuel oil and exhaust gases that push past the piston rings. Crankcase dilution is caused more when the lube oil is fresher. [3] Another cause of crankcase dilution is a slow or delayed injection ...
The oil is dyed blue to make it easier to recognize in the gasoline. It appears black in this bottle because it is not diluted. Two-stroke oil (also referred to as two-cycle oil, 2-cycle oil, 2T oil, or 2-stroke oil) is a special type of motor oil intended for use in crankcase compression two-stroke engines, typical of small gasoline-powered ...
Oil bodies are the organelle that has evolved to hold triglycerides in plant cells. They are therefore the principal store of chemical energy in oleaginous seeds. The structure and composition of plant seed oil bodies has been the subject of research from at least as far back as the 1980s, with several papers published in the 80s and 90s.
The following formulas can be used to calculate the volumes of solute (V solute) and solvent (V solvent) to be used: [1] = = where V total is the desired total volume, and F is the desired dilution factor number (the number in the position of F if expressed as "1/F dilution factor" or "xF dilution"). However, some solutions and mixtures take up ...
Engine oil is recirculated around a four-stroke engine (rather than burning it as happens in a two-stroke engine) and much of this occurs within the crankcase. Oil is stored either at the bottom of the crankcase (in a wet sump engine) or in a separate reservoir (in a dry sump system). [3]
In a wet-sump engine, oil slosh against spinning parts causes substantial viscous drag which creates parasitic power loss. [5] [6] A dry-sump system removes oil from the crankcase, along with the possibility of such viscous drag. More complex dry-sump systems may scavenge oil from other areas where oil may pool, such as in the valvetrain.
Hot-bulb engine (two-stroke). 1. Hot bulb. 2. Cylinder. 3. Piston. 4. Crankcase Old Swedish hot-bulb engine in action. The hot-bulb engine, also known as a semi-diesel [1] or Akroyd engine, is a type of internal combustion engine in which fuel ignites by coming in contact with a red-hot metal surface inside a bulb, followed by the introduction of air (oxygen) compressed into the hot-bulb ...
Concentrates must be diluted before use at a ratio of 10–20 ml concentrate per litre of water and placed in a spray bottle or sprayer. [13] [10] [9] As with ready-to-use spray bottles or cans, the mixture is applied to all surfaces of a plant's leaves and stems. [8] [9] [10] [11]