Ads
related to: what is stud length 2x4 drywall home depot 4x12homedepot.com has been visited by 1M+ users in the past month
Search results
Results From The WOW.Com Content Network
Wall studs are framing components in timber or steel-framed walls, that run between the top and bottom plates.It is a fundamental element in frame building. The majority non-masonry buildings rely on wall studs, with wood being the most common and least-expensive material used for studs.
Interior walls with 1 sheet of 1 ⁄ 2-inch (13 mm) gypsum wallboard on either side of 2x4 (1 + 1 ⁄ 2 in × 3 + 1 ⁄ 2 in or 38 mm × 89 mm) wood studs spaced 16 inches (410 mm) on-center with no fiberglass insulation filling each stud cavity have an STC of about 33. [14]
The top and bottom plates are end-nailed to each stud with two nails at least 3 + 1 ⁄ 4 in (83 mm) in length (16d or 16-penny nails). Studs are at least doubled (creating posts) at openings, the jack stud being cut to receive the lintels (headers) that are placed and end-nailed through the outer studs. [10] Moisture barrier sheathing with ...
Blocking placed as attachment points for cabinets, while doubling as bracing against compression of the studs. Blocking ( dwang , nog, noggin, and nogging) is the use of short pieces of dimensional lumber in wood framed construction to brace longer members or to provide grounds for fixings.
Various sized cuts of 1 ⁄ 2 in (13 mm) drywall with tools for maintenance and installation . Drywall (also called plasterboard, dry lining, [1] wallboard, sheet rock, gib board, gypsum board, buster board, turtles board, slap board, custard board, gypsum panel and gyprock) is a panel made of calcium sulfate dihydrate (), with or without additives, typically extruded between thick sheets of ...
A stud finder (also stud detector or stud sensor) is a handheld device used with wood buildings to locate framing studs located behind the final walling surface, usually drywall. While there are many different stud finders available, most fall into two main categories: magnetic stud detectors and electric stud finders.
In light-frame construction, a trimmer is a timber or metal beam (joist) used to create an opening around a stairwell, skylight, chimney, and the like. Trimmers are installed parallel to the primary floor or ceiling joists and support headers, which run perpendicular to the primary joists.
Typically they range in size from 30 by 48 inches (76 cm × 122 cm) to 36 by 60 inches (91 cm × 152 cm). They are, as one would expect, considerably heavier than the gypsum core type panels. Portland cement based panels are ideal for truly wet locations like shower surrounds and for locations where a Portland cement based thin-set material is ...