Ads
related to: hobby oxy acetylene torch settings
Search results
Results From The WOW.Com Content Network
Tests [citation needed] showed that an oxy-gasoline torch can cut steel plate up to 0.5 in (13 mm) thick at the same rate as oxy-acetylene. In plate thicknesses greater than 0.5 in (13 mm) the cutting rate was better than that of oxy-acetylene; at 4.5 in (110 mm) it was three times faster. [10]
A set of MAPP and oxygen cylinders is used for oxy-fuel welding and cutting.. MAPP gas was a trademarked name, belonging to The Linde Group, a division of the former global chemical giant Union Carbide, for a fuel gas based on a stabilized mixture of methylacetylene (propyne), propadiene and propane.
2.1 Shut off oxygen first or acetylene first? 3 Instructional content. 9 comments. 4 RfM. 1 comment. 5 Mediation. 6 comments. 6 More historical information. 7 ...
The torch used for lead burning is a small, hot, gas flame. Oxy-acetylene is most commonly used, as it is easily portable. A small size #0 nozzle is usually used, sometimes with a miniature torch body, but the torch is otherwise the same as that used for steel or copper work.
The term "blowtorch" is commonly misused as a name for any metalworking torch, but properly describes the pressurized liquid fuel torches that predate the common use of pressurized fuel gas cylinders. Torches are available in a vast range of size and output power. The term "blowtorch" applies to the obsolescent style of smaller liquid fuel torches.
One end of the tube is placed in a holder and oxygen is fed through the tube. The far end of the tube is pre-heated and lit by an oxyacetylene torch. An intense stream of burning steel is produced at the working end and can be used to cut rapidly through thick materials, including steel and concrete. [2]