Ads
related to: stop valve leaks when closed tube frequency is higher
Search results
Results From The WOW.Com Content Network
The importance of valve leakage depends on what the valve is controlling. For example, a dripping tap is less significant than a leak from a six-inch pipe carrying high-pressure radioactive steam. In the United States, the American National Standards Institute specifies six different leakage classes, with "leakage" defined in terms of the full ...
Schematic symbol used in circuit diagrams for a vacuum tube, showing control grid. The control grid is an electrode used in amplifying thermionic valves (vacuum tubes) such as the triode, tetrode and pentode, used to control the flow of electrons from the cathode to the anode (plate) electrode. The control grid usually consists of a cylindrical ...
A representative valve preamp from the 1950s is the Leak 'varislope' series of preamps, which included a switchable rumble filter, a switchable scratch filter with selectable slopes and corner frequency, continuously variable treble and bass tone controls and a selection of 4 different gramophone equalisations (RIAA, ortho, RCA, 78).
For pentodes, it is higher, about (5-7)/g m. Valves with high g m thus tend to have lower noise at high frequencies. In the audio frequency range (below 1–100 kHz), "1/f" noise becomes dominant, which rises like 1/f. Thus, valves with low noise at high frequency do not necessarily have low noise in the audio frequency range.
The pentagrid converter is a type of radio receiving valve (vacuum tube) with five grids used as the frequency mixer stage of a superheterodyne radio receiver. The pentagrid was part of a line of development of valves that were able to take an incoming RF signal and change its frequency to a fixed intermediate frequency , which was then ...
Example of symbol for a stop valve. A stopcock is a form of valve used to control the flow of a liquid or gas. The term is not precise and is applied to many different types of valve. The only consistent attribute is that the valve is designed to completely stop the flow when closed fully.