Search results
Results From The WOW.Com Content Network
A conic section, conic or a quadratic curve is a curve obtained from a cone's surface intersecting a plane. The three types of conic section are the hyperbola , the parabola , and the ellipse ; the circle is a special case of the ellipse, though it was sometimes considered a fourth type.
More generally, every irreducible cubic surface (possibly singular) over an algebraically closed field is rational unless it is the projective cone over a cubic curve. [2] In this respect, cubic surfaces are much simpler than smooth surfaces of degree at least 4 in P 3 {\displaystyle \mathbf {P} ^{3}} , which are never rational.
In general, a conical surface consists of two congruent unbounded halves joined by the apex. Each half is called a nappe, and is the union of all the rays that start at the apex and pass through a point of some fixed space curve. [2] Sometimes the term "conical surface" is used to mean just one nappe. [3]
Diagram showing a section through the centre of a cone (1) subtending a solid angle of 1 steradian in a sphere of radius r, along with the spherical "cap" (2). The external surface area A of the cap equals r2 only if solid angle of the cone is exactly 1 steradian. Hence, in this figure θ = A/2 and r = 1.
Proposition 11: The volume of a cone (or cylinder) of the same height is proportional to the area of the base. [6] Proposition 12: The volume of a cone (or cylinder) that is similar to another is proportional to the cube of the ratio of the diameters of the bases. [7] Proposition 18: The volume of a sphere is proportional to the cube of its ...
The Egyptians knew the correct formula for the volume of such a truncated square pyramid, but no proof of this equation is given in the Moscow papyrus. The volume of a conical or pyramidal frustum is the volume of the solid before slicing its "apex" off, minus the volume of this "apex":
The section volumes are then totaled to determine the overall volume of the tree or part of the tree being modeled. In general most sections are treated as frustums of a cone, paraboloid, or neiloid, where the diameter at each end and the length of each section is determined to calculate volume. Direct measurements are obtained by a tree ...
The surface-area-to-volume ratio has physical dimension inverse length (L −1) and is therefore expressed in units of inverse metre (m −1) or its prefixed unit multiples and submultiples. As an example, a cube with sides of length 1 cm will have a surface area of 6 cm 2 and a volume of 1 cm 3. The surface to volume ratio for this cube is thus