When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Stitch and glue - Wikipedia

   en.wikipedia.org/wiki/Stitch_and_glue

   The one sheet boat (OSB, cf. oriented strand board) is an outgrowth of the stitch and glue technique. The OSB is a boat that can be built using a single sheet of 4 foot by 8 foot plywood (1.22 m × 2.44 m). Some additional wood is often used, for supports, chines, or as a transom, though some can be built entirely with the sheet of plywood ...

3. Boat building - Wikipedia

   en.wikipedia.org/wiki/Boat_building

   A subdivision of the sheet plywood boat building method is known as the stitch-and-glue method, [8] where pre-shaped panels of plywood are drawn together then edge glued and reinforced with fibreglass without the use of a frame. [9] Metal or plastic ties, nylon fishing line or copper wires pull curved flat panels into three-dimensional curved ...

4. Sheet (sailing) - Wikipedia

   en.wikipedia.org/wiki/Sheet_(sailing)

   A mainsheet is a line connected to the boom which allows a sailor to control the speed of a boat. The jib sheet attaches to the clew of the jib, and controls it. The jib has a sheet on each side, only one of which (the leeward one) will be in use at one time. The spinnaker sheet attaches to the clew(s) of the spinnaker, if carried. A ...

5. Revere Copper Company - Wikipedia

   en.wikipedia.org/wiki/Revere_Copper_Company

   In 1803, the Department of the Navy commissioned Revere to roll copper sheets to sheathe the hull of USS Constitution. Originally, the Navy had contracted Revere to roll the sheets using a cold rolling technique, but Revere petitioned to roll them hot, with a final cold pass after they annealed. Revere was confident in his technique of mixing ...

6. Lofting - Wikipedia

   en.wikipedia.org/wiki/Lofting

   Lofting is particularly useful in boat building, when it is used to draw and cut pieces for hulls and keels. These are usually curved, often in three dimensions . Loftsmen at the mould lofts of shipyards were responsible for taking the dimensions and details from drawings and plans, and translating this information into templates, battens ...

7. Chine (boating) - Wikipedia

   en.wikipedia.org/wiki/Chine_(boating)

   As the boat's speed increases, hydrodynamic pressure beneath the pad causes the hull to ride higher in the water, so that eventually the boat will be riding solely upon the pad area. At low speeds these hulls ride and handle similarly to a comparable V-hull; but at high speeds the padded hull can both out-accelerate and have a higher top speed ...