Search results
Results From The WOW.Com Content Network
The value of η ∞ represents the lowest viscosity attainable and may be orders of magnitude lower than η 0, depending on the degree of shear thinning. Viscosity is plotted against shear rate in a log(η) vs. log(˙) plot, where the linear region is the shear-thinning regime and can be expressed using the Ostwald and de Waele power law ...
A Newtonian fluid is a power-law fluid with a behaviour index of 1, where the shear stress is directly proportional to the shear rate: = These fluids have a constant viscosity, μ, across all shear rates and include many of the most common fluids, such as water, most aqueous solutions, oils, corn syrup, glycerine, air and other gases.
Note that all thixotropic fluids are extremely shear thinning, but they are significantly time dependent, whereas the colloidal "shear thinning" fluids respond instantaneously to changes in shear rate. Thus, to avoid confusion, the latter classification is more clearly termed pseudoplastic. Another example of a shear thinning fluid is blood.
The following equation illustrates the relation between shear rate and shear stress for a fluid with laminar flow only in the direction x: =, where: τ x y {\displaystyle \tau _{xy}} is the shear stress in the components x and y, i.e. the force component on the direction x per unit surface that is normal to the direction y (so it is parallel to ...
The viscosity of a non-Newtonian fluid is defined by a power law: [5] = ˙ where η is the viscosity after shear is applied, η 0 is the initial viscosity, γ is the shear rate, and if <, the fluid is shear thinning, >, the fluid is shear thickening,
A single viscosity measurement at a constant speed in a typical viscometer is a measurement of the instrument viscosity of a fluid (not the apparent viscosity). In the case of non-Newtonian fluids, measurement of apparent viscosity without knowledge of the shear rate is of limited value: the measurement cannot be compared to other measurements if the speed and geometry of the two instruments ...
At low shear rate (˙ /) a Carreau fluid behaves as a Newtonian fluid with viscosity .At intermediate shear rates (˙ /), a Carreau fluid behaves as a Power-law fluid.At high shear rate, which depends on the power index and the infinite shear-rate viscosity , a Carreau fluid behaves as a Newtonian fluid again with viscosity .
Time-dependent shear thickening behavior. Thixotropy: The longer a fluid is subjected to a shear force, the lower its viscosity. It is a time-dependent shear thinning behavior. Shear thickening: Similar to rheopecty, but independent of the passage of time. Shear thinning: Similar to thixotropy, but independent of the passage of time.