Ads
related to: 5 band resistor chart
Search results
Results From The WOW.Com Content Network
A 2.26 kΩ, 1%-precision resistor with 5 color bands (), from top, 2-2-6-1-1; the last two brown bands indicate the multiplier (×10) and the tolerance (1%).. An electronic color code or electronic colour code (see spelling differences) is used to indicate the values or ratings of electronic components, usually for resistors, but also for capacitors, inductors, diodes and others.
[4] [5] [6] Black Bananas Really Offend Your Girlfriend But Violets Get Welcomed. Black Birds Run Over Your Gay Barely Visible Grey Worms. Badly Burnt Resistors On Your Ground Bus Void General Warranty. Billy Brown Ran Out Yelling Get Back Violets Getting Wet. Better Be Right Or You're Gonna Be Violently Gouged With Golden Spaghetti.
A single resistor may be used, or a pair (half bridge), or four resistors connected in a Wheatstone bridge configuration. The strain resistor is bonded with adhesive to an object that is subjected to mechanical strain. With the strain gauge and a filter, amplifier, and analog/digital converter, the strain on an object can be measured.
For example, a 10 ohm resistor connected in parallel with a 5 ohm resistor and a 15 ohm resistor produces 1 / 1/10 + 1/5 + 1/15 ohms of resistance, or 30 / 11 = 2.727 ohms. A resistor network that is a combination of parallel and series connections can be broken up into smaller parts that are either one or the other.
A similar non-standard notation using the unit symbol instead of a decimal separator is sometimes used to indicate voltages (i.e. 0V8 for 0.8 V, 1V8 for 1.8 V, 3V3 for 3.3 V or 5V0 for 5.0 V [24] [25] [26]) in contexts where a decimal separator would be inappropriate (e.g. in signal or pin names, in file names, or in labels or subscripts).
Since some values of the E24 series do not exist in the E48, E96, or E192 series, some resistor manufacturers have added missing E24 values into some of their 1%, 0.5%, 0.25%, 0.1% tolerance resistor families. This allows easier purchasing migration between various tolerances.
Figure 5. Parallel RC, series L circuit with resistance in parallel with the capacitor. In the same vein, a resistor in parallel with the capacitor in a series LC circuit can be used to represent a capacitor with a lossy dielectric. This configuration is shown in Figure 5.
An axial-lead through-hole zero-ohm resistor is generally marked with a single black band, [6] the symbol for "0" in the resistor color code. Surface-mount zero-ohm resistors are usually marked with a single or multiple "0" (if size allows marking), where the number of digits can indicate the tolerance or maximum resistance rating, as is the ...