Search results
Results From The WOW.Com Content Network
Air flow meter; Air–fuel ratio meter; Blind spot monitor; Crankshaft position sensor (CKP) Curb feeler; Defect detector; Engine coolant temperature sensor; Hall effect sensor; Wheel speed sensor; Airbag sensors; Automatic transmission speed sensor; Brake fluid pressure sensor; Camshaft position sensor (CMP) Cylinder Head Temperature gauge ...
Latency, from a general point of view, is a time delay between the cause and the effect of some physical change in the system being observed. Lag, as it is known in gaming circles, refers to the latency between the input to a simulation and the visual or auditory response, often occurring because of network delay in online games.
The sensor has an input port to measure the hydraulic braking pressure and an electrical connector output for a wire connection for feeding the warning light. Some brake failures do not trip the sensor into a fault mode. A brake fluid pressure sensor is used in anti-lock braking system (ABS). ABS fault lights come on with unexpected wheel lock ...
A control loop is the fundamental building block of control systems in general and industrial control systems in particular. It consists of the process sensor, the controller function, and the final control element (FCE) which controls the process necessary to automatically adjust the value of a measured process variable (PV) to equal the value of a desired set-point (SP).
MAF sensor in a 2006-2015 automotive diesel engine. A mass (air) flow sensor (MAF) is a sensor used to determine the mass flow rate of air entering a fuel-injected internal combustion engine. The air mass information is necessary for the engine control unit (ECU) to balance and deliver the correct fuel mass to the engine. Air changes its ...
This depth is converted to a flow rate according to a theoretical formula of the form = where is the flow rate, is a constant, is the water level, and is an exponent which varies with the device used; or it is converted according to empirically derived level/flow data points (a "flow curve"). The flow rate can then be integrated over time into ...
This act affects all light motor vehicles sold after September 1, 2007. Phase-in started in October 2005 at 20%, and reached 100% for models produced after September 2007. In the United States, as of 2008 and the European Union, as of November 1, 2012, all new passenger car models released must be equipped with a TPMS. From November 1, 2014 ...
These may feature a sensor bulb sited within the main chamber of the oven. In addition, there may be a safety cut-off flame supervision device: after ignition, the burner's control knob must be held for a short time in order for a sensor to become hot, and permit the flow of gas to the burner. If the safety sensor becomes cold, this may ...