Ads
related to: 383 bare block for sale
Search results
Results From The WOW.Com Content Network
There were a few different versions of the LT1. All feature a cast iron block, with aluminum heads in the Y- and F-bodies, and cast iron heads in the B- and D-bodies. Corvette blocks had four-bolt main caps, while most other blocks were two-bolt main caps. Block castings remained the same between 2 and 4 bolt mains.
The Ford MEL is a big-block 90° V8 engine family produced in various configurations by the Ford Motor Company between 1958 and 1967 in displacements from 383–462 cubic inches (6.3–7.6 L), and used in Ford, Edsel, Mercury, and Lincoln vehicles.
The Chrysler B and RB engines are a series of big-block V8 gasoline engines introduced in 1958 to replace the Chrysler FirePower (first generation Hemi) engines. The B and RB engines are often referred to as "wedge" engines because they use wedge-shaped combustion chambers; this differentiates them from Chrysler's 426 Hemi big block engines that are typically referred to as "Hemi" or "426 Hemi ...
The Pontiac V8 engine is a family of overhead valve 90° V8 engines manufactured by the Pontiac Division of General Motors Corporation between 1955 and 1981. The engines feature a cast-iron block and head and two valves per cylinder.
The big-block 383 was replaced by a larger-bore (and lower performance) 400 CID version as the standard engine. The small-block 340 CID and the performance version of the 440 CID engine (with a 4-barrel carburetor, performance camshaft, and dual exhausts) were also available, and for the last time, a 4-speed manual transmission could be paired ...
Christina Haack introduces her contractor and design partner during the Jan. 29 series premiere of The Flip Off. The HGTV star was originally supposed to compete alongside her third husband Josh ...
Its block was bored out to 4.04 in (102.6 mm) but its 3.31 in (84.1 mm) stroke left unchanged, resulting in the 340 cu in (5.6 L) engine introduced for the 1968 model year. Anticipating higher loads resulting from racing operation, the engineers fitted a forged shot peened steel crankshaft instead of the cast steel unit used in the 318. This ...
The top-oiler block sent oil to the top center first, the side-oiler block sent oil along a passage located on the lower side of the block first. All FE and FT engines have a bore spacing of 4.630 in (117.6 mm), and a deck height (distance from crank center to top of block) of 10.170 in (258.3 mm). The main journal (crankshaft bearing) diameter ...