Ad
related to: setting up a 10 bolt chevy rear end gear ratio chart 8 8 mustang
Search results
Results From The WOW.Com Content Network
There are three pinion offsets for the Dana 70 rear axle. 1 ⁄ 2, 5 ⁄ 8 and 31 ⁄ 32 inch (13, 16 and 25 mm) offset. The first Dana 70 axles had a 1 ⁄ 2-inch (13 mm) pinion offset and were found in Dana 70HD's as well. The drawback with the 1 / 2-inch offset was that a 4.10:1
Identification between the two can be made by examining the hub: the protrusion of the hub through the center of the wheel denotes the preferred 10.5-inch full-floating rear axle. While the 9.5-inch rear end exhibits its own durability, it is generally considered less favorable for high-torque applications. The 9.5-inch C-clip rear differential ...
A variation of the Dana 60 known as a Dana 61 was made to accommodate gear ratios that allowed for better fuel mileage. This was done as a direct result of the 1973 oil crisis. A 3.07:1 gear ratio was common for these axles and unachievable in a regular Dana 60. To allow for the different gearing, the Dana 61 had a greater pinion offset.
It can be identified by its straight axle tubes, 10 bolt asymmetrical cover, and a "80" cast into the housing. Dana 80's are made as full floating, rear axles only and are a step up in overall strength compared to the Dana 70. 1988 Ford was the first company to use the Dana 80.
The Sterling 10.5 axle is an automotive axle manufactured by Ford Motor Company at the Sterling Axle Plant in Sterling Heights, MI. It was first used in model year 1985 Ford trucks. The axle was developed to replace the Dana 60 and Dana 70. The Sterling 10.5 axle is currently only made as a full floating axle.
Spur-gear differential. A spur-gear differential has equal-sized spur gears at each end, each of which is connected to an output shaft. [8] The input torque (i.e. from the engine or transmission) is applied to the differential via the rotating carrier. [8] Pinion pairs are located within the carrier and rotate freely on pins supported by the ...
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
The 2.2l S10/Sonoma had the starter located in the same position as front wheel drive cars. A rear wheel drive bellhousing is displayed at right, and the integrated front wheel drive bellhousing is displayed at the lower right (in this case, as a part of the GM 6T70 Transmission). GM 60-Degree 2.8/3.1/3.4/3.5/3.9 L V6 (also used by AMC) Buick ...