Ads
related to: setting up a 10 bolt chevy rear end gear ratio chart for 67 firebird ls3 swap
Search results
Results From The WOW.Com Content Network
There are three pinion offsets for the Dana 70 rear axle. 1 ⁄ 2, 5 ⁄ 8 and 31 ⁄ 32 inch (13, 16 and 25 mm) offset. The first Dana 70 axles had a 1 ⁄ 2-inch (13 mm) pinion offset and were found in Dana 70HD's as well. The drawback with the 1 / 2-inch offset was that a 4.10:1
The 10.5" 14-bolt differential and axle is quite popular with Jeep Wrangler owners who want to upgrade their standard Dana 30, Dana 35, or Dana 44 axle. While the 10.5" 14-bolt axle is heavier than the standard Dana axles offered on the Wrangler, it is much stronger. This increased strength allows Jeep Wrangler owners to mount up to 44" tires ...
Originally this axle was made as the Sterling 10.25, with a ring gear that measured 10.25 inches (260 mm) until it was upgraded in 1999 to the Sterling 10.50 for the Ford Super Duty trucks. The 10.25 axle came with drum brakes. There were two versions of the Sterling 10.25. The first version was produced from 1985 to 1992.
A variation of the Dana 60 known as a Dana 61 was made to accommodate gear ratios that allowed for better fuel mileage. This was done as a direct result of the 1973 oil crisis. A 3.07:1 gear ratio was common for these axles and unachievable in a regular Dana 60. To allow for the different gearing, the Dana 61 had a greater pinion offset.
The 2.2l S10/Sonoma had the starter located in the same position as front wheel drive cars. A rear wheel drive bellhousing is displayed at right, and the integrated front wheel drive bellhousing is displayed at the lower right (in this case, as a part of the GM 6T70 Transmission). GM 60-Degree 2.8/3.1/3.4/3.5/3.9 L V6 (also used by AMC) Buick ...
Front Axle. GM 1967-1976 K5(Blazer/Jimmy)/K10/K20 (Passenger side) Some 1977 K5 Blazers came with Dana 44s in the front, others came with a Corporate 10 bolt solid front axle. Dana 44s were also used as front axles in 4x4 converted full size Chevrolet and GMC vans by Pathfinder Equipment Company from 1973 to 1989. Dodge
Also found in wide and narrow ratio configurations. Muncie SM319 transmission — 3-speed transmission physically identical to the Muncie SM318, with an added Borg Warner overdrive unit. Muncie SM420 transmission — 4-speed manual used up to 1967, very similar to sm 465 except small changes to gear ratios and location of reverse.
The W72 Performance Package also included an upgrade to the rear differential ratio, setting the rear gear ratio to 3.23 for all 1977 and 1979 W72 Firebirds, with the exception being 3.42 for 4-speed equipped W72 Firebirds in 1978 only. All W72 equipped Trans Ams featured the "T/A 6.6" shaker decal.