Ads
related to: wheel stopper dimension from the wall hole bolt set for concrete anchorstirerack.com has been visited by 100K+ users in the past month
Search results
Results From The WOW.Com Content Network
The anchor selection, together with additional reinforcement, and rigging arrangements is influenced by: - The dead weight of the element - The number of anchors in the element and the configuration of the anchor - Capacity of the anchor at the specific concrete compressive strengths at time of lift - The dynamic loads applied during lifting ...
Anchor bolts transfer different types of load: tension forces and shear forces. [3] A connection between structural elements can be represented by steel columns attached to a reinforced concrete foundation. [4] A common case of a non-structural element attached to a structural one is the connection between a facade system and a reinforced ...
Other varieties of wall plug are mechanical anchors for heavy duty loads and hollow wall fixings for fixing to plasterboard. The first mechanical anchor, the Rawlbolt, was designed in the 1930s by the Rawlplug company and the first fixing for hollow walls was the Toggle Bolt, which was also designed by Rawlplug in 1941.
Figure 1 of the original patent for the molly bolt, U.S. Patent No. 2,018,251. The molly bolt was patented in 1934 by George Frederick Croessant. [3] Although his patent acknowledges that expandable fasteners of this general kind were already known, Croessant's patent is intended to provide "an improved and adequate anchoring grip that may be retightened if necessary and that will permit ...
Nominal (thread) sizes range from 0.1875 to 0.375 in (4.763 to 9.525 mm) and lengths from 1.25 to 5 in (32 to 127 mm). Typically an installer uses a hammer drill to make a pilot hole for each concrete screw and a powered impact driver to drive the screw. The drill hole should be 1/2" longer than the depth penetration of the screw.
A hold-down may also refer to clamping device used to anchor a pipe to a structural steel element or concrete floor or allow movement of the pipe in an axial direction. [1] At the bottom, the hold down is connected to the concrete foundation or structural slab by an embedded or epoxied anchor bolt. At the top, the hold down is connected to a ...