Ads
related to: cross bracing with turnbuckle length chart mm
Search results
Results From The WOW.Com Content Network
This bracing is known by many names such as herringbone strutting, blocking, bridging, and dwanging. Cross bracing on a bridge tower. In construction, cross bracing is a system utilized to reinforce building structures in which diagonal supports intersect. Cross bracing is usually seen with two diagonal supports placed in an X-shaped manner.
A turnbuckle, stretching screw or bottlescrew is a device for adjusting the tension or length of ropes, cables, tie rods, and other tensioning systems. It normally consists of two threaded eye bolts , one screwed into each end of a small metal frame, one with a conventional right-hand thread and the other with a left-hand thread.
Bracing it with an extra diagonal bar would be heavy. A wire would be much lighter but would stop it collapsing only one way. To hold it rigid, two cross-bracing wires are needed. This method of cross-bracing can be seen clearly on early biplanes, where the wings and interplane struts form a rectangle which is cross-braced by wires.
A few sizes are close enough to interchange for most purposes, such as 19 mm (close to 3 ⁄ 4 inch (19.05 mm)), 8 mm (close to 5 ⁄ 16 inch (7.94 mm)) and 4 mm (close to 5 ⁄ 32 inch (3.97 mm)). In reality, a wrench with a width across the flats of exactly 15 mm would fit too tightly to use on a bolt with a width across the flats of 15 mm.
As cross-bracing cannot normally be added, vertical stiffeners on the girders are normally used to prevent buckling (technically described as 'U-frame behaviour' [5]). This form of bridge is most often used on railroads as the construction depth (distance between the underside of the vehicle, and the underside of the bridge) is much less.
In general, because the ratio of the typical tie rod's length to its cross section is usually very large, it would buckle under the action of compressive forces.The working strength of a tie rod is the product of the allowable working stress and the rod's minimum cross-sectional area.
Ad
related to: cross bracing with turnbuckle length chart mm