Search results
Results From The WOW.Com Content Network
FPM, EDO, SDR, and RDRAM memory was not commonly installed in a dual-channel configuration. DDR and DDR2 memory is usually installed in single- or dual-channel configuration. DDR3 memory is installed in single-, dual-, tri-, and quad-channel configurations. Bit rates of multi-channel configurations are the product of the module bit-rate (given ...
The network on chip is a router-based packet switching network between SoC modules. NoC technology applies the theory and methods of computer networking to on-chip communication and brings notable improvements over conventional bus and crossbar communication architectures .
Supermicro AOC-SGP-I2 dual-port Gigabit Ethernet NIC, a PCI Express ×4 card. 1000BASE-T (also known as IEEE 802.3ab) is a standard for Gigabit Ethernet over twisted-pair wiring. Each 1000BASE-T network segment is recommended to be a maximum length of 100 meters (330 feet), [5] [a] and must use Category 5 cable or better (including Cat 5e and ...
A router [a] is a computer and networking device that forwards data packets between computer networks, including internetworks such as the global Internet. [2] [3] [4] Routers perform the "traffic directing" functions on the Internet. A router is connected to two or more data lines from different IP networks.
The network controller implements the electronic circuitry required to communicate using a specific physical layer and data link layer standard such as Ethernet or Wi-Fi. [a] This provides a base for a full network protocol stack, allowing communication among computers on the same local area network (LAN) and large-scale network communications through routable protocols, such as Internet ...
Router with two dozen 10 Gigabit Ethernet ports and three types of physical-layer module. 10 Gigabit Ethernet (abbreviated 10GE, 10GbE, or 10 GigE) is a group of computer networking technologies for transmitting Ethernet frames at a rate of 10 gigabits per second. It was first defined by the IEEE 802.3ae-2002 standard.
This representation does have certain limitations. Given sufficient graphics processing power even graphics programmers would like to use better formats, such as floating point data formats, to obtain effects such as high-dynamic-range imaging. Many GPGPU applications require floating point accuracy, which came with video cards conforming to ...
Although vendors claimed that 100 Gbit/s light paths could use existing analog optical infrastructure, deployment of high-speed technology was tightly controlled and extensive interoperability tests were required before moving them into service. Designing routers or switches which support 100 Gbit/s interfaces is difficult.