Search results
Results From The WOW.Com Content Network
A theoretical plate in many separation ... increases the number of plates required. Hence, the calculation of N t is ... formula known as Van Winkle's ...
Fractionation at total reflux. The Fenske equation in continuous fractional distillation is an equation used for calculating the minimum number of theoretical plates required for the separation of a binary feed stream by a fractionation column that is being operated at total reflux (i.e., which means that no overhead product distillate is being withdrawn from the column).
N = Number of theoretical plates. α = Selectivity Term = k 2 '/k 1 ' The [N 1/2 /4] term is the column factor, the [(α-1)/α] term is the thermodynamic factor, and the [k 2 '/(1+k 2 ')] term is the retention factor. The 3 factors are not completely independent, but they are very close, and can be treated as such. So what does this mean?
The theoretical plate height is given by = where L is the column length and N the number of theoretical plates. [5] The relation between plate number and peak width ...
The number of steps between the operating lines and the equilibrium line represents the number of theoretical plates (or equilibrium stages) required for the distillation. For the binary distillation depicted in Figure 1, the required number of theoretical plates is 6. Constructing a McCabe–Thiele diagram is not always straightforward.
The variance per unit length of the column is taken as the ratio of the column length to the column efficiency in theoretical plates. The van Deemter equation is a hyperbolic function that predicts that there is an optimum velocity at which there will be the minimum variance per unit column length and, thence, a maximum efficiency. The van ...
Vibration mode of a clamped square plate. The vibration of plates is a special case of the more general problem of mechanical vibrations.The equations governing the motion of plates are simpler than those for general three-dimensional objects because one of the dimensions of a plate is much smaller than the other two.
The typical thickness to width ratio of a plate structure is less than 0.1. [citation needed] A plate theory takes advantage of this disparity in length scale to reduce the full three-dimensional solid mechanics problem to a two-dimensional problem. The aim of plate theory is to calculate the deformation and stresses in a plate subjected to loads.