Ads
related to: fixing rafters to ridge board and siding corners on a house plans
Search results
Results From The WOW.Com Content Network
Eaves of a house in Northern Australia. The white underside would be referred to as a soffit. In this example the soffit is fixed to the slope of the rafters. The dark grey fascia boards form the outer edge and have a groove to receive the soffit lining sheets which cover the rafter tails. Boxed in soffit on a house in Northern Florida, United ...
A lookout, [1] lookout rafter or roof outlooker [2] is a wooden joist that extends in cantilever out from the exterior wall (or wall plate) of a building, supporting the roof sheathing and providing a nailing surface for the fascia boards. When not exposed it serves to fasten the finish materials of the eaves.
It is built with corner post construction on the ground floor, half-timbered style of timber framing on the upper floor and has a less common style of wood roof shingles than typical in America. American historic carpentry is the historic methods with which wooden buildings were built in what is now the United States since European settlement.
The top ends of the rafters often meet at a ridge beam, but may butt directly to another rafter to form a pair of rafters called a couple. Depending on the roof covering material, either horizontal laths , battens , or purlins are fixed to the rafters; or boards, plywood , or oriented strand board form the roof deck (also called the sheeting or ...
The horizontal "fascia board" which caps the end of rafters outside a building may be used to hold the rain gutter. The finished surface below the fascia and rafters is called the soffit or eave. In classical architecture, the fascia is the plain, wide band (or bands) that make up the architrave section of the entablature, directly above the ...
The trim and rafters at this edge are called rakes, rake board, rake fascia, verge-boards, barge-boards or verge-or barge-rafters. [3] It is a sloped timber on the outside facing edge of a roof running between the ridge and the eave. [4] On a typical house, any gable will have two rakes, one on each sloped side.