Search results
Results From The WOW.Com Content Network
Finally, NCO scabbards had only two scabbard mounts, consisting of a top mount with frog stud and a scabbard tip, whereas officers' scabbards bore three mounts, including upper and middle mounts fitted with carrying rings. [2] [3] The sword worn by Marine NCOs since 1859 was also carried throughout the American Civil War. With only slight ...
In 1898 the brass scabbard was replaced by a steel scabbard of the same form. [12] The pattern was also adopted for field marshals, royal equerries and lords lieutenant of counties, with only minor differences in decoration. The cross-guard écusson decoration of crossed baton and sabre is replaced by two crossed batons for field marshals ...
A scabbard is a sheath for holding a sword, dagger, knife, or similar edged weapons. Rifles and other long guns may also be stored in scabbards by horse riders for transportation. Military cavalry and cowboys had scabbards for their saddle ring carbines and rifles for transportation and protection.
The Pattern 1907 bayonet, officially called the Sword bayonet, pattern 1907 (Mark I), is an out-of-production British bayonet designed to be used with the Short Magazine Lee Enfield (SMLE) rifle. The Pattern 1907 bayonet was used by the British and Commonwealth forces throughout both the First and Second World Wars .
The sword had a 31-inch (79 cm) blade (some being slightly longer), a cast brass hilt resembling the more expensive wire-wrapped leather grips, and a leather scabbard rather than the steel used by cavalry troopers and officers, although some makers, such as Emerson and Silver, issued a steel scabbard rather than leather to protect from wear.
The M-1956 LCE continued application of the belt-supported-by-suspenders concept, adopted by the U.S. Army at least as early as the pattern 1903 equipment. [2] The M-1956 "Belt, Individual Equipment" or pistol belt differed little in form and function from the M-1936 pistol belt and would accommodate any of the pouches and equipment that would mount on the M-1936 belt.
Henry V. Allien & Company submitted five pattern swords for the uniform board's consideration, three with straight blades and two with curved, and the Ordnance Department submitted a similar number. The result was that of the ten patterns, one of the Allien swords was adopted, the very one approved by General Kelton.
The scabbard was similar to the 1804 Pattern, with the same lack of locket which again often allowed the frog hook to pull out from the leather. The 1845 Pattern featured an acute point, making it more useful than its predecessor for thrusting which was now emphasised in the navy's drill manuals. [9]