Search results
Results From The WOW.Com Content Network
Hydraulically activated pipeline pigging (HAPP) is a pigging technology applied for pipeline cleaning. The basic principle is that a pressure drop is created over a by-passable pig held back against a pipeline's fluid flow. The pipeline fluid passing through the pig's cleaning head is accelerated by this pressure drop, forming strong cleaning jets.
Pigs are used in lube oil or paint blending to clean the pipes to avoid cross-contamination, and to empty the pipes into the product tanks (or sometimes to send a component back to its tank). Usually pigging is done at the beginning and at the end of each batch, but sometimes it is done in the midst of a batch, such as when producing a premix ...
Ice pigging is a technique used for cleaning pipes, distinguished from traditional pigging by the use of a semi-solid 'pig' made of ice, rather than a solid object. This ice pig is capable of flowing through pipes, navigating obstructions such as valves and variations in pipe diameter, due to its fluid-like properties.
Download as PDF; Printable version; In other projects ... Pages in category "Pigging" ... Pipe drift; S. Slugcatcher
Pipe classes and piping line numbers; Flow directions; Interconnections references; Permanent start-up, flush and bypass lines; Pipelines and flowlines; Blinds and spectacle blinds; Insulation and heat tracing; Process control instrumentation and designation (names, numbers, unique tag identifiers), including:
Pipeline Filling (Flooding) – which can be carried out by propelling pigs through the pipeline with water or free flooding with water (normally for smaller or unpiggable pipelines). Hydrotesting – this is a process by which the pipeline in question is pressure tested to a predefined pressure above the operating design pressure of the pipeline.
For small diameter pipes there may not be enough room for the tractor mechanism. Instead, a somewhat rigid "fish" is pushed through the pipe and attached to a rope at the access point near the truck. The fish is then pulled to place the rope along the pipe. The rope is then used to pull the inspection pig and cable through the pipe.
Process piping and power piping are typically checked by pipe stress engineers to verify that the routing, nozzle loads, hangers, and supports are properly placed and selected such that allowable pipe stress is not exceeded under different loads such as sustained loads, operating loads, pressure testing loads, etc., as stipulated by the ASME B31, EN 13480, GOST 32388, RD 10-249 or any other ...