Ads
related to: jacobs chuck taper chart pdf download
Search results
Results From The WOW.Com Content Network
The Jacobs Taper (abbreviated JT) is commonly used to secure drill press chucks to an arbor. The taper angles are not consistent varying from 1.41° per side for No. 0 (and the obscure # 2 + 1 ⁄ 2) to 2.33° per side for No. 2 (and No. 2 short). There are also several sizes between No. 2 and No. 3: No. 2 short, No. 6 and No. 33.
The chuck may be held against the taper with a threaded retainer ring (large thin nut), typically wrenched with a spanner wrench of the pin or hook variety. The peak of popularity for building this type of spindle nose was the 1940s and 1950s. The chuck may be held against the taper with cam-lock posts that wedge into a stuck-fast position.
The number refers to the Association for Manufacturing Technology (formerly the National Machine Tool Builders Association (NMTB)) taper size of the tool. A CAT-40 toolholder A boring head on a Morse taper shank. An improvement on CAT Tooling is Bridgeport Taper (BT) Tooling, which looks similar and can easily be confused with CAT tooling.
Several machine collets (top and centre) and a dismantled pin chuck (below). Generally, a collet chuck, [3] considered as a unit, consists of a tapered receiving sleeve (sometimes integral with the machine spindle), the collet proper (usually made of spring steel) which is inserted into the receiving sleeve, and (often) a cap that screws over the collet, clamping it via another taper.
Both the tool and socket have a slight taper. The contemporary square drive screw has all but replaced the Robertson screw proper and is commonly referred to as a Robertson because it has practically identical drive dimensions and the same colour identification system, but the contemporary square drive socket has parallel sides rather than tapered.
Cutting speed may be defined as the rate at the workpiece surface, irrespective of the machining operation used. A cutting speed for mild steel of 100 ft/min is the same whether it is the speed of the cutter passing over the workpiece, such as in a turning operation, or the speed of the cutter moving past a workpiece, such as in a milling operation.
This feature gives the taper tap a very gradual cutting action that is less aggressive than that of the plug tap. The number of tapered threads typically ranges from 8 to 10. [2] A taper tap is most often used when the material is difficult to work (e.g., alloy steel) or the tap is of a very small diameter and thus prone to breakage. Power taps
Over time, various chuck designs have been invented, and modern chucks can grasp and drive this shank effectively. It has been difficult to find a reference to the included angle of the taper, but 7 different bits were measured, and they all had an included angle of 8 ± 0.25 degrees. Easy to make in a forge