Search results
Results From The WOW.Com Content Network
IEEE 1547-2003 had a tight underfrequency protection setting of 59.3 Hz which posed a risk for grid stability. In case of an underfrequency situation, [3] e.g. after a major loss of generation, the situation may get worse when a multitude of distributed energy resources (DER) disconnect simultaneously.
Typically, a grid code will specify the required behavior of a connected generator during system disturbances. These include voltage regulation , power factor limits and reactive power supply, response to a system fault (e.g. short-circuit ), response to frequency changes on the grid, and requirement to " ride through " short interruptions of ...
The electrical power grid that powers Northern America is not a single grid, but is instead divided into multiple wide area synchronous grids. [1] The Eastern Interconnection and the Western Interconnection are the largest. Three other regions include the Texas Interconnection, the Quebec Interconnection, and the Alaska Interconnection.
In a grid containing many distributed generators subject to disconnection at under voltage, it is possible to cause a chain reaction that takes other generators offline as well. This can occur in the event of a voltage dip that causes one of the generators to disconnect from the grid. As voltage dips are often caused by too little generation ...
The Global Release Identifier (GRid) is a system to identify releases of digital sound recordings (and other digital data) for electronic distribution. It is designed to be integrated with identification systems deployed by key stakeholders from across the music industry .
Grid-tie inverters are designed to disconnect quickly from the grid if the utility grid goes down. In the United States, there is an NEC requirement [ 2 ] that in the event of a blackout, the grid tie inverter shut down to prevent the electricity it generates from harming persons repairing the power grid.
An electrical grid may have many types of generators and loads; generators must be controlled to maintain stable operation of the system. In an electric power system, automatic generation control (AGC) is a system for adjusting the power output of multiple generators at different power plants, in response to changes in the load. Since a power ...
The Open Charge Point Protocol (OCPP) is an application protocol for communication between Electric vehicle (EV) charging stations and a central management system, also known as a charging station network, similar to cell phones and cell phone networks.