Ads
related to: 12 point nut standard size table placemats template
Search results
Results From The WOW.Com Content Network
For example, "agate" and "ruby" used to be a single size "agate ruby" of about 5 points; [2] metal type known as "agate" later ranged from 5 to 5.8 points. The sizes were gradually standardized as described above. [3] Modern Chinese typography uses the following names in general preference to stating the number of points.
Patterns - Up to ten patterns can be indicated with each call of the {} template, using the first ten unnamed parameters. Dot patterns for the standard alphabet in both upper and lower case are indicated with the letter - e.g. {{ NYP |b}} → and {{ NYP |B}} → .
The standard designation for a UTS thread is a number indicating the nominal (major) diameter of the thread, followed by the pitch measured in threads per inch.For diameters smaller than 1 / 4 inch, the diameter is indicated by an integer number defined in the standard; for all other diameters, the inch figure is given.
However, 12 Fournier points turned out to be 11 Didot points, [11]: 142–145 giving a Fournier point of about 0.345 mm; later sources [12]: 60–61 state it as being 0.348 75 mm. To avoid confusion between the new and the old sizes, Didot also rejected the traditional names, thus parisienne became corps 5, nonpareille became corps 6, and so on.
A table of standard sizes for machine screws as provided by the American Screw Company of Providence, Rhode Island, USA, and published in a Mechanical Engineers' Handbook of 1916. Standards seen here overlap with those found elsewhere marked as ASME and SAE standards and with the later Unified Thread Standard (UTS) of 1949 and afterward.
One pica is further divided into 12 points. In printing, three pica measures are used: The French pica of 12 Didot points (also called cicero) generally is: 12 × 0.376 = 4.512 mm (0.1776 in). The American pica of 0.16604 inches (4.217 mm). It was established by the United States Type Founders' Association in 1886.