Ads
related to: fluorescent light fixture part names
Search results
Results From The WOW.Com Content Network
Fluorescent light fixtures cannot be connected to dimmer switches intended for incandescent lamps. Two effects are responsible for this: the waveform of the voltage emitted by a standard phase-control dimmer interacts badly with many ballasts, and it becomes difficult to sustain an arc in the fluorescent tube at low power levels.
Cross section of a typical fluorescent lamp with and without a reflector. Some lamps have an internal opaque reflector. Coverage of the reflector ranges from 120° to 310° of the lamp's circumference. Reflector lamps are used when light is only desired to be emitted in a single direction, or when an application requires the maximum amount of ...
Circular and U-shaped lamps were devised to reduce the length of fluorescent light fixtures. The first fluorescent light bulb and fixture were displayed to the general public at the 1939 New York World's Fair. The spiral CFL was invented in 1976 by Edward E. Hammer, an engineer with General Electric, [7] in response to the 1973 oil crisis. [8]
The suffix after the G indicates the pin spread; the G dates to the use of Glass for the original bulbs. GU usually also indicates that the lamp provides a mechanism for physical support by the luminaire: in some cases, each pin has a short section of larger diameter at the end (sometimes described as a "peg" rather than a "pin" [2]); the socket allows the bulb to lock into place by twisting ...
The name comes from the shape of the housing. The term "pot lights" is often used in Canada and parts of the US. Cove light – indirect lighting recessed into the ceiling in a long box against a wall. Troffer – recessed fluorescent light fixtures, usually rectangular in shape to fit into a drop ceiling grid.
It can be incorporated into an existing fluorescent light fixture or mounted remotely outside of it. When power is lost, the ballast will illuminate one or more lamps in the fixture at a reduced output for a minimum of 90 minutes (as required by code). These can be used as an alternative to egress lighting powered by a back-up electrical generator.