Search results
Results From The WOW.Com Content Network
Kinetic friction, also known as dynamic friction or sliding friction, occurs when two objects are moving relative to each other and rub together (like a sled on the ground). The coefficient of kinetic friction is typically denoted as μ k, and is usually less than the coefficient of static friction for the same materials.
In fluid dynamics, the Darcy friction factor formulae are equations that allow the calculation of the Darcy friction factor, a dimensionless quantity used in the Darcy–Weisbach equation, for the description of friction losses in pipe flow as well as open-channel flow.
The proportionality coefficient is the dimensionless "Darcy friction factor" or "flow coefficient". This dimensionless coefficient will be a combination of geometric factors such as π, the Reynolds number and (outside the laminar regime) the relative roughness of the pipe (the ratio of the roughness height to the hydraulic diameter).
Traction can also refer to the maximum tractive force between a body and a surface, as limited by available friction; when this is the case, traction is often expressed as the ratio of the maximum tractive force to the normal force and is termed the coefficient of traction (similar to coefficient of friction).
Sliding friction (also called kinetic friction) is a contact force that resists the sliding motion of two objects or an object and a surface. Sliding friction is almost always less than that of static friction; this is why it is easier to move an object once it starts moving rather than to get the object to begin moving from a rest position.
All coefficients are in general functions of temperature and composition, and they are called friction functions. In order to achieve high accuracy over a wide pressure and temperature ranges, it turned out that a second order term was needed even for non-polar molecules types such as hydrocarbon fluids in oil and gas reservoirs, in order to ...
Fanning friction factor for tube flow. This friction factor is one-fourth of the Darcy friction factor, so attention must be paid to note which one of these is meant in the "friction factor" chart or equation consulted. Of the two, the Fanning friction factor is the more commonly used by chemical engineers and those following the British ...
is the rolling resistance coefficient or coefficient of rolling friction with dimension of length, and N {\displaystyle N} is the normal force (equal to W , not R , as shown in figure 1). The above equation, where resistance is inversely proportional to radius r {\displaystyle r} seems to be based on the discredited "Coulomb's law" (Neither ...