Search results
Results From The WOW.Com Content Network
The Universal Transverse Mercator (UTM) is a map projection system for assigning coordinates to locations on the surface of the Earth.Like the traditional method of latitude and longitude, it is a horizontal position representation, which means it ignores altitude and treats the earth surface as a perfect ellipsoid.
Informally, specifying a geographic location usually means giving the location's latitude and longitude. The numerical values for latitude and longitude can occur in a number of different units or formats: [2] sexagesimal degree: degrees, minutes, and seconds : 40° 26′ 46″ N 79° 58′ 56″ W
The intersection of a UTM zone and a latitude band is (normally) a 6° × 8° polygon called a grid zone, whose designation in MGRS is formed by the zone number (one or two digits – the number for zones 1 to 9 is just a single digit, according to the example in DMA TM 8358.1, Section 3-2, [1] Figure 7), followed by the latitude band letter ...
The most common horizontal position representation is latitude and longitude. The parameters are intuitive and well known, and are thus suited for communicating a position to humans, e.g. using a position plot. However, latitude and longitude should be used with care in mathematical expressions (including calculations in computer programs).
To convert Transverse Mercator coordinates to lat-lon, first calculate ′, the footprint latitude— i.e. the latitude of the point on the central meridian that has the same N as the point to be converted; i.e. the latitude that has a meridian distance on the spheroid equal to N/. Bowring's formulas below seem quickest, but traditional ...
Grid Zone Designation (GZD); for a world-wide unique address. This consists of up to 2 digits (6-degree longitude UTM zone) for West to East, followed by a letter (8-degree latitude band) from South to North; in this example, "18S". [10] [11] 100,000-meter (100 km) Square Identification; for regional areas.
The set of parameters can vary based on the type of project and the conventions chosen for the projection. For the transverse Mercator projection used in UTM, the parameters associated are the latitude and longitude of the natural origin, the false northing and false easting, and an overall scale factor. [7]
(On the sphere it depends on both latitude and longitude.) The scale is true on the central meridian. • The projection is reasonably accurate near the equator. Scale at an angular distance of 5° (in latitude) away from the equator is less than 0.4% greater than scale at the equator, and is about 1.54% greater at an angular distance of 10°. •