Ad
related to: detroit cam gear timing chart
Search results
Results From The WOW.Com Content Network
The Detroit Diesel Series 60 is an inline-six 4 stroke diesel engine produced from 1987 to 2011. At that time, it differed from most on-highway engines by using an overhead camshaft and "drive by wire" electronic control. In 1993, it was popular on many USA buses in the 11.1 L (677 cu in) displacement.
The crankshaft drives the camshaft (via a timing belt, timing chain or gears), which in turn actuates the intake and exhaust valves. [1] These valves allow the engine to inhale air (or an air/fuel mixture) and exhale the exhaust gasses. [2] The most common devices to transfer the drive are toothed rubber belts, metal timing chains or a set of ...
For twin-cam or DOHC engines, VCT was used on either the intake or exhaust camshaft. (Engines that have VCT on both camshafts are now designated as Ti-VCT.↓) The use of variable camshaft timing on the exhaust camshaft is for improved emissions, and vehicles with VCT on the exhaust camshaft do not require exhaust gas recirculation (EGR) as retarding the exhaust cam timing achieves the same ...
The Detroit Diesel Series 110 is a two-stroke diesel engine series, available in straight-6 cylinder configuration (in keeping with the standard Detroit Diesel practice at the time, engines were referred to using a concatenation of the number of cylinders and the displacement, so this was a model 6-110).
The Series 92 engines were introduced in 1974. [8] Compared to the Series 71 engines they were derived from, the Series 92 featured a larger bore of 4.84025 ± 0.00125 in (122.942 ± 0.032 mm) and an identical stroke of 5 in (130 mm) for a nominal displacement per cylinder of 92 cu in (1,510 cc), from which the Series 92 derives its name.
The inline six-cylinder 71 series engine was introduced as the initial flagship product of the Detroit Diesel Engine Division of General Motors in 1938.. This engine was in high demand during WWII, necessitating a dramatic increase in output: about 57,000 6-71s were used on American landing craft, including 19,000 on LCVPs, about 8,000 on LCM Mk 3, and about 9,000 in quads on LCIs; and 39,000 ...
The cam can be seen as a device that converts rotational motion to reciprocating (or sometimes oscillating) motion. [clarification needed] [3] A common example is the camshaft of an automobile, which takes the rotary motion of the engine and converts it into the reciprocating motion necessary to operate the intake and exhaust valves of the cylinders.
SOHC design (for a 1973 Triumph Dolomite Sprint) . The oldest configuration of overhead camshaft engine is the single overhead camshaft (SOHC) design. [1] A SOHC engine has one camshaft per bank of cylinders, therefore a straight engine has a total of one camshaft and a V engine or flat engine has a total of two camshafts (one for each cylinder bank).