Ads
related to: random antenna wire
Search results
Results From The WOW.Com Content Network
Often random wire antennas are also (inaccurately) referred to as long-wire antennas.There is no accepted minimum size, but actual long-wire antennas must be greater than at least a quarter-wavelength ( 1 / 4 λ) or perhaps greater than a half ( 1 / 2 λ) at the frequency the long wire antenna is used for, and even a half-wave may only be considered "long-ish" rather than "truly ...
Assuming the building is about 20 feet tall, the length of wire seems to be on the order of 100 feet long – too short to be an HF Beverage antenna. Random wire antenna Moxon (1993) describes the random-wire antenna as an "odd bit of wire". [14] [page needed] It is the typical informal antenna erected for receiving shortwave and AM radio.
4 Random wire antenna used for transmitting avoids resonant lengths. 1 comment. Toggle the table of contents. Talk: Random wire antenna. Add languages.
A transmatch (antenna tuner) is not required to use this antenna near its nominal design frequency of 14 MHz, and judicious length adjustments can sometimes include one other frequency band. All other frequencies require a transmatch. [citation needed] There are many variants of the G5RV antenna. Two variations of the G5RV design, called ZS6BKW ...
The antenna feedpoint is usually high in the air (for example, a dipole antenna) or far away (for example, an end-fed random wire antenna). A transmission line, or feedline, must carry the signal between the transmitter and the antenna. The ATU can be placed anywhere along the feedline: at the transmitter, at the antenna, or somewhere in between.
The angle of the slope is usually between 45°–60° and the lower end of the wire is at least 1 ⁄ 6 wavelength above the electrical ground. [3] A sloper is typically fed with a coaxial cable in the center, at the top of the center support mast. At least 1 ⁄ 4 of the wavelength of feedline must be at 90° angle to the antenna. [3]