Ads
related to: rotor blade stall lock assembly replacement
Search results
Results From The WOW.Com Content Network
The effect of dynamic stall limits the helicopter performance in several ways such as: The maximum forward flight velocity and thrust; High blade structural loads, which may result in excessive vibrations and blade structural damage; Control system loads, manoeuvre capability, and handling qualities; Helicopter dynamic performance.
In a stationary hover, each rotor blade will experience the same airspeed at a constant RPM. In forward flight conditions, one rotor blade will be moving into the oncoming air stream while the other moves away from it. At certain airspeeds, this can create a dangerous condition in which the receding rotor blade stalls, causing unstable flight. [5]
A helicopter's main rotor hub. The vertical rods are at the end of the control chain that starts with the pilot controls. Helicopter flight controls are connected to the main and tail rotors, and include a cyclic stick, broadly to control forward-aft and left-right movements, a collective lever, broadly to control vertical movements, and anti-torque pedals, to control left and right yaw.
Retreating blade stall is a hazardous flight condition in helicopters and other rotary wing aircraft, where the retreating rotor blade has a lower relative blade speed, combined with an increased angle of attack, causing a stall and loss of lift. Retreating blade stall is the primary limiting factor of a helicopter's never exceed speed, V NE. [1]
At the top of the mast is the attachment point (colloquially called a Jesus nut) for the rotor blades called the hub. The rotor blades are then attached to the hub, and the hub can have 10-20 times the drag of the blade. [1] Main rotor systems are classified according to how the main rotor blades are attached and move relative to the main rotor ...
Linkages (silver) to the rotor blade In aeronautics , a swashplate is a mechanical device that translates input via the helicopter flight controls into motion of the main rotor blades . Because the main rotor blades are spinning, the swashplate is used to transmit three of the pilot's commands from the non-rotating fuselage to the rotating ...
Phase lag may vary depending on rotor tilt rate, ratio of aerodynamic damping to blade inertial forces (Lock number), offset of flapping hinge from axis of rotation (e/R ratio), and coupling of blade flap, drag, and feather motions, and often results in cross-coupling between the aircraft control axes. Phase lag is a property of all rotating ...
The rotorhead is where the lift force from the rotor blades act. The rotorhead is connected to the main drive shaft via the Jesus nut, and houses several other components such as the swash plate, flight control linkages and fly-bars. [1] The rotor hub is also where the centre of gravity acts on the helicopter. The rotor head of a Sikorsky S-92