When.com Web Search

  1. Ads

    related to: difference between 12v 24v 48v and battery charging handle for car

Search results

  1. Results From The WOW.Com Content Network
  2. 48-volt electrical system - Wikipedia

    en.wikipedia.org/wiki/48-volt_electrical_system

    A 48 V system can provide more power, improve energy recuperation, [7] and allow up to an 85% decrease in cable mass. [10]12-volt systems can provide only 3.5 kilowatts, while a 48 V power could achieve 15 to 20 kW or even 50 kW. 48 volts is below the level that is considered safe in dry conditions without special protective measures. [11]

  3. Automobile auxiliary power outlet - Wikipedia

    en.wikipedia.org/wiki/Automobile_auxiliary_power...

    The actual voltage, matching the car battery's voltage, will be approximately 12.5 volts when dormant (less in cold conditions), approximately 14.5 volts when the engine and the alternator/generator are operating (more when cold), and may briefly drop as low as 5–6 volts during engine start due to the high temporary battery current usage. [12]

  4. Charge controller - Wikipedia

    en.wikipedia.org/wiki/Charge_controller

    Due to limitations in currents that copper wires could safely handle, charging protocols have been developed to allow the end device to request elevated voltages for increasing the power throughput without increasing heat in the wires. The arriving voltage is then converted down to the battery's optimum charging voltage inside the end device. [10]

  5. 42-volt electrical system - Wikipedia

    en.wikipedia.org/wiki/42-volt_electrical_system

    Literature on 42-volt electrical systems often refers to systems powered with a 6-cell lead-acid battery as nominally 14 volts. Depending on operating conditions, the vehicle electrical system voltage today can vary between 6.5 and 16 V, with a varying degree of ripple superimposed on this value.

  6. Electric car charging methods - Wikipedia

    en.wikipedia.org/wiki/Electric_car_charging_methods

    Constant voltage charging is a widely used charging method involving constant voltage between the battery poles. The starter battery uses constant voltage charging when the vehicle is running. If the specified voltage constant value is appropriate, it can ensure that the battery is fully charged, while also minimizing gas and water loss.

  7. Battery terminal - Wikipedia

    en.wikipedia.org/wiki/Battery_terminal

    General Motors, and other automobile manufacturers, have also begun using side-post battery terminals, which consist of two recessed female 3/8" threads (SAE 3/8-16) into which bolts or various battery terminal adapters are to be attached. These side posts are of the same size and do not prevent incorrect polarity connections.