Search results
Results From The WOW.Com Content Network
The RMS over all time of a periodic function is equal to the RMS of one period of the function. The RMS value of a continuous function or signal can be approximated by taking the RMS of a sample consisting of equally spaced observations. Additionally, the RMS value of various waveforms can also be determined without calculus, as shown by ...
In electronics and electrical engineering, the form factor of an alternating current waveform (signal) is the ratio of the RMS (root mean square) value to the average value (mathematical mean of absolute values of all points on the waveform). [1] It identifies the ratio of the direct current of equal power relative to the given alternating ...
True RMS provides a more correct value that is proportional to the square root of the average of the square of the curve, and not to the average of the absolute value. For any given waveform , the ratio of these two averages is constant and, as most measurements are made on what are (nominally) sine waves, the correction factor assumes this ...
The usual waveform of alternating current in most electric power circuits is a sine wave, whose positive half-period corresponds with positive direction of the current and vice versa (the full period is called a cycle). "Alternating current" most commonly refers to power distribution, but a wide range of other applications are technically ...
Various properties of ripple voltage may be important depending on application: the equation of the ripple for Fourier analysis to determine the constituent harmonics; the peak (usually peak-to-peak) value of the voltage; the root mean square (RMS) value of the voltage which is a component of power transmitted; the ripple factor γ, the ratio ...
The root mean square value of a waveform is the DC value that corresponds to equivalent heating value. rotary converter An electric machine that converts electric power between two forms, say, AC and DC or single-phase and three phase, or between two different frequencies of AC (the latter two can be performed by the same machine). rotary encoder
where V n is the RMS value of the nth harmonic voltage, and V 1 is the RMS value of the fundamental component. In practice, the THD F is commonly used in audio distortion specifications (percentage THD); however, THD is a non-standardized specification, and the results between manufacturers are not easily comparable. Since individual harmonic ...
The ratio of the rms value of the harmonic content of an alternating quantity to the rms value of the fundamental component of the quantity. turn-off arm An auxiliary arm which temporarily takes over the current directly from a conducting valve arm, consisting of one or more latching valve devices which cannot be turned off by a control signal.