When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. G-10 (material) - Wikipedia

   en.wikipedia.org/wiki/G-10_(material)

   G-10 or garolite is a high-pressure fiberglass laminate, a type of composite material. [1] It is created by stacking multiple layers of glass cloth, soaked in epoxy resin, then compressing the resulting material under heat until the epoxy cures. [2] [3] It is manufactured in flat sheets, most often a few millimeters thick.

3. FR-4 - Wikipedia

   en.wikipedia.org/wiki/FR-4

   FR-4 (or FR4) is a NEMA grade designation for glass-reinforced epoxy laminate material. FR-4 is a composite material composed of woven fiberglass cloth with an epoxy resin binder that is flame resistant ( self-extinguishing ).

4. Steel grades - Wikipedia

   en.wikipedia.org/wiki/Steel_grades

   EN 10027-1 steel grade designation system. European standard steel grade names fall into two categories: [1] Steel specified by purpose of use and mechanical properties. Steel specified by chemical composition. The inclusion of a letter 'G' before the code indicates the steel is specified in the form of a casting.

5. Plywood - Wikipedia

   en.wikipedia.org/wiki/Plywood

   [citation needed] At 3 ⁄ 8 inch (9.5 mm) thick, mahogany three-ply "wiggle board" or "bendy board" come in 4 by 8 feet (1.2 m × 2.4 m) sheets with a very thin cross-grain central ply and two thicker exterior plies, either long grain on the sheet, or cross grain. Wiggle board is often glued together in two layers once it is formed into the ...

6. Sheet metal - Wikipedia

   en.wikipedia.org/wiki/Sheet_metal

   Sheet metal is available in flat pieces or coiled strips. The coils are formed by running a continuous sheet of metal through a roll slitter. In most of the world, sheet metal thickness is consistently specified in millimeters. In the U.S., the thickness of sheet metal is commonly specified by a traditional, non-linear measure known as its ...

7. SAE steel grades - Wikipedia

   en.wikipedia.org/wiki/SAE_steel_grades

   The SAE steel grades system is a standard alloy numbering system (SAE J1086 – Numbering Metals and Alloys) for steel grades maintained by SAE International. In the 1930s and 1940s, the American Iron and Steel Institute (AISI) and SAE were both involved in efforts to standardize such a numbering system for steels.