Ads
related to: 4l60e torque converter lockup solenoid
Search results
Results From The WOW.Com Content Network
Beginning in 1998 a new 300mm torque converter with improved higher-capacity internals, 300mm style input shaft, and 300mm style pump was also introduced on models coupled to a Gen III Small Block. The 4L60E is rated to handle up to 360 ft⋅lb (490 N⋅m) of torque. It weighs 133 pounds without transmission fluid. [1]
In 1995, the 4L60E received a PWM-controlled lockup converter. The early designs simple on or off lockup function while the later design can regulate the apply pressure as to not feel the lock up occur. GM added a fifth solenoid to the valve body, called the PWM solenoid. In 1996, GM introduced a redesigned 4L60E transmission case that ...
Once fully locked, the torque converter no longer applies torque multiplication and will spin at the same speed as the engine. This provides a major increase in fuel economy. Modern designs provide partial lockup in lower gears to improve fuel economy further, but this can increase wear on the clutch components.
The 6L 50 (and similar 6L 45) is a 6-speed longitudinally-mounted automatic transmission produced by General Motors.It is very similar in design to the larger GM 6L 80 and 6L 90, and is produced at GM Powertrain plants in Toledo, Ohio; Silao, Guanajuato, Mexico; and by the independent Punch Powerglide company in Strasbourg, France.
Although not strictly a part of classic torque converter design, many automotive converters include a lock-up clutch to improve cruising power transmission efficiency and reduce heat. The application of the clutch locks the turbine to the impeller, causing all power transmission to be mechanical, thus eliminating losses associated with fluid drive.
During the 1980s, automatic transmissions with four gear ratios became increasingly common, [31] and many were equipped with lock-up torque convertors in order to improve fuel economy. Electronics began to be more commonly used to control the transmission, replacing mechanical control methods such as spring-loaded valves in the valve body.
Crankshafts manufactured for the 1999 model year (to the end of 4.3 L (262 cu in) production) had a pilot hole depth of 1.41 in (35.8 mm) when coupled to the LSx-based 4L60E, which had a redesigned torque converter pilot hub (which was longer and was used with a 300 mm (11.8 in) stator shaft).
1946–1953 M5/M6 Presto-Matic — 4-speed (2 gear manual with electric overdrive) with clutch and fluid coupling (Fluid Drive) or torque converter (Fluid Torque Drive); also known as Tip-Toe Shift, Gyro-Matic, Fluid-Matic, Gyro-Torque; 1953–1954 Hy-Drive — 3-speed manual transmission behind a torque converter