Search results
Results From The WOW.Com Content Network
Mold is a dangerous library pest because of the damage it causes to the collections. Mold thrives off of paper and books; these objects provide the fungi a source of nutrition, namely the sugar and starches present in the cellulose materials. [6] Mold feeds on cloth, leather, glues, adhesives, cellulose starch and starches in the sizing.
Rising damp is the effect of water rising from the ground into property. [3] The damp proof course may be horizontal or vertical. [4] A DPC layer is usually laid below all masonry walls, regardless if the wall is a load bearing wall or a partition wall. A damp-proof membrane (DPM) is a membrane material
More personnel could decide to leave the military because of poor accommodation if action is not taken, the report warns.
Falling accidents at home are very common and can cause serious and life-threatening injuries, so prevention of slip and trip accidents is essential in the good design of living quarters. This objective is especially important for the elderly and disabled, who may have restricted movement and be more susceptible to hazards .
Here's why mold grows on food, what happens when you eat it, and tips to keep food mold-free. What is mold? Molds are microscopic fungi, Josephine Wee, Ph.D., an assistant professor of food ...
An example of a damp proof course of slate in a brick wall intended to prevent rising damp. A physical damp proof course made from plastic can be installed into an existing building by cutting into short sections of the mortar course, and installing short sections of the damp proof course material.
Indoor mold (American English) or indoor mould (British English), also sometimes referred to as mildew, is a fungal growth that develops on wet materials in interior spaces. Mold is a natural part of the environment and plays an important part in nature by breaking down dead organic matter such as fallen leaves and dead trees; indoors, mold ...
Compression molding is a method of molding in which the molding material, generally preheated, is first placed in an open, heated mold cavity. The mold is closed with a top force or plug member, pressure is applied to force the material into contact with all mold areas, while heat and pressure are maintained until the molding material has cured; this process is known as compression molding ...