Search results
Results From The WOW.Com Content Network
ESP32 is a series of low-cost, low-power system-on-chip microcontrollers with integrated Wi-Fi and dual-mode Bluetooth.The ESP32 series employs either a Tensilica Xtensa LX6 microprocessor in both dual-core and single-core variations, an Xtensa LX7 dual-core microprocessor, or a single-core RISC-V microprocessor and includes built-in antenna switches, RF balun, power amplifier, low-noise ...
Thread is an IPv6-based, low-power mesh networking technology for Internet of things (IoT) products. [1] The Thread protocol specification is available at no cost; however, this requires agreement and continued adherence to an end-user license agreement (EULA), which states "Membership in Thread Group is necessary to implement, practice, and ship Thread technology and Thread Group specifications."
Arduino Uno WiFi rev 2 [4] ATMEGA4809, NINA-W132 Wi-Fi module from u-blox, ECC608 crypto device 16 MHz Arduino / Genuino 68.6 mm × 53.4 mm [ 2.7 in × 2.1 in ] USB-A 32U4 5 V 48 0.25 6 FH 14 5 6 0 Announced May 17, 2018: Contains six-axis accelerometer, gyroscope the NINA/esp32 module supports Wi-Fi and support Bluetooth as Beta feature [5]
Wi-Fi microcontrollers enable Wi-Fi connectivity for devices so that they can send & receive data and accept commands. As such, Wi-Fi microcontrollers can be used for bringing otherwise ordinary devices into the realm of the Internet of things .
Next generation Wi-Fi known as 802.11ax provides low delay, high capacity (up to 10 Gbit/s) and low packet loss rate, offering 12 streams – 8 streams at 5 GHz and 4 streams at 2.4 GHz. IEEE 802.11ax uses 8x8 MU-MIMO, OFDMA, and 80 MHz channels. Hence, 802.11ax has the ability to form high capacity Wi-Fi ad hoc networks.
IEEE 802.15.4 protocol stack. Devices are designed to interact with each other over a conceptually simple wireless network.The definition of the network layers is based on the OSI model; although only the lower layers are defined in the standard, interaction with upper layers is intended, possibly using an IEEE 802.2 logical link control sublayer accessing the MAC through a convergence sublayer.
Some systems are designed for point-to-point line-of-sight communications, once two such nodes get too far apart they can no longer communicate. Other systems are designed to form a wireless mesh network using one of a variety of routing protocols. In a mesh network, when nodes get too far apart to communicate directly, they can still ...
An SD-card size wireless-enabled breadboard friendly Arduino compatible board running at 16 MHz/3.3 V. It can mate with either an RFM12B or RFM69W/HW/CW transceiver from HopeRF, allowing very low cost wireless communication (also available without a transceiver).