Ads
related to: rim lock wheel immobilizers replacement chart for sale 1 14 12
Search results
Results From The WOW.Com Content Network
A standard beadlock is designed to clamp the tire bead between an outer and an inner ring. The inner ring may be welded onto a standard wheel increasing wheel width by anywhere from 1 + 1 ⁄ 2 to 2 inches (3.8 to 5.1 cm) or may be formed as part of the wheel when the wheel is made in the factory. The outer ring is then bolted onto the inner ...
Its nomenclature, "14-bolt," represents the 14 bolts securing the differential cover, although the ring gear itself is fastened by 12 bolts. Notably, the 14-bolt differential gained traction among Jeep Wrangler owners seeking axle replacement options, [2] earning the moniker "corporate" 14-bolt because of its association with GM's corporate ...
A rim lock is a locking device that attaches to the surface of a door. [1] It is the oldest type of lock used in the United Kingdom and Ireland. It is of a basic design using (usually) a single lever and a sliding bolt. Wards can be used for additional security. They are not used where high security is required. Most older locks were large ...
A wheel clamp, also known as wheel boot, parking boot, or Denver boot, [1] [2] is a device that is designed to prevent motor vehicles from being moved. In its most common form, it consists of a clamp that surrounds a vehicle wheel, designed to prevent removal of both itself and the wheel.
The electric immobiliser/alarm system was invented by St. George Evans and Edward Birkenbeuel and patented in 1919. [2] They developed a 3x3 grid of double-contact switches on a panel mounted inside the car so when the ignition switch was activated, current from the battery (or magneto) went to the spark plugs allowing the engine to start, or immobilizing the vehicle and sounding the horn. [3]
Replacement keys, which can be purchased through the dealer or a 3rd party, must be compatible with the vehicle. Before the key can be used to start the vehicle it must be programmed, done by inserting the original key(s) as well as the new key into the ignition. With PATS I, programming of a new key can be done with just one working key.