Ads
related to: width of a window frame in feet height
Search results
Results From The WOW.Com Content Network
trimmer or jack − stud to the left or right of a window or door that runs from the bottom plate to the underside of a lintel or header; cripple stud – a stud located either above or below a framed opening, that does not run the full height of the wall; post or column − a doubled or other integral multiple of a group of studs nailed side ...
A window sill in the most general sense is a horizontal structural element below a window opening or window unit in masonry construction or framed construction and is regarded as part of the window frame. The bottom of a window frame sits on top of the window sill of the wall opening. [1] A window sill may span the entire width of a wall from ...
A window is an opening in a wall, door, roof, or vehicle that allows the exchange of light and may also allow the passage of sound and sometimes air.Modern windows are usually glazed or covered in some other transparent or translucent material, a sash set in a frame [1] in the opening; the sash and frame are also referred to as a window. [2]
The name "hung sash window", which is more usual in the United States than in the United Kingdom, typically refers to a double-hung window with two sashes that can move up and down in the window frame. These windows are commonly found in older buildings in warmer climates, as they promote airflow and are easy to clean.
The building has a roof height of 1,250 feet (380 m) and stands a total of 1,454 feet (443.2 m) tall, including its antenna. The Empire State Building was the world's tallest building until the first tower of the World Trade Center was topped out in 1970 ; following the September 11 attacks in 2001, the Empire State Building was New York City's ...
Braced frame construction, also known as full frame, half frame, [6] New England braced frame, [7] combination frame [8] an early form of light framing which survived into the 1940s in the northeastern United States, [9] defined by the continued use of girts, corner posts, and braces, most often mortised, tenoned, and pegged with nailed studs. [8]