Search results
Results From The WOW.Com Content Network
In computer science, a data buffer (or just buffer) is a region of memory used to store data temporarily while it is being moved from one place to another. Typically, the data is stored in a buffer as it is retrieved from an input device (such as a microphone) or just before it is sent to an output device (such as speakers); however, a buffer may be used when data is moved between processes ...
Bus encoding refers to converting/encoding a piece of data to another form before launching on the bus.While bus encoding can be used to serve various purposes like reducing the number of pins, compressing the data to be transmitted, reducing cross-talk between bit lines, etc., it is one of the popular techniques used in system design to reduce dynamic power consumed by the system bus.
In digital electronics, a tri-state or three-state buffer is a type of digital buffer that has three stable states: a high output state, a low output state, and a high-impedance state. In the high-impedance state, the output of the buffer is disconnected from the output bus, allowing other devices to drive the bus without interference from the ...
Bus snooping or bus sniffing is a scheme by which a coherency controller (snooper) in a cache (a snoopy cache) monitors or snoops the bus transactions, and its goal is to maintain a cache coherency in distributed shared memory systems. This scheme was introduced by Ravishankar and Goodman in 1983, under the name "write-once" cache coherency. [1]
Four PCI Express bus card slots (from top to second from bottom: ×4, ×16, ×1 and ×16), compared to a 32-bit conventional PCI bus card slot (very bottom). In computer architecture, a bus (historically also called a data highway [1] or databus) is a communication system that transfers data between components inside a computer or between computers. [2]
The bus-invert encoding technique uses an extra signal (INV) to indicate the "polarity" of the data. Having a bus-invert code word INV@x where @ is the concatenation operator and x denotes either the source word or its ones' complement, the bus-invert decoder takes the code word and produces the corresponding source word. If the INV signal is 1 ...
A digital buffer (or a logic buffer) is an electronic circuit element used to copy a digital input signal and isolate it from any output load.For the typical case of using voltages as logic signals, a logic buffer's input impedance is high, so it draws little current from the input circuit, to avoid disturbing its signal.
Careful usage generally talks about "500 MHz, double data rate" or "1000 MT/s", but many refer casually to a "1000 MHz bus," even though no signal cycles faster than 500 MHz. DDR SDRAM popularized the technique of referring to the bus bandwidth in megabytes per second , the product of the transfer rate and the bus width in bytes.