Search results
Results From The WOW.Com Content Network
The finished surface below the fascia and rafters is called the soffit or eave. In classical architecture, the fascia is the plain, wide band (or bands) that make up the architrave section of the entablature, directly above the columns. The guttae or drip edge was mounted on the fascia in the Doric order, below the triglyph.
Bargeboard, 1908 illustration. A bargeboard or rake fascia is a board fastened to each projecting gable of a roof to give it strength and protection, and to conceal the otherwise exposed end grain of the horizontal timbers or purlins of the roof.
To remove the mortar, contractors often aggressively clean the walls with pressurized water or acid solutions, which can open up additional voids and increase the possibility of water penetration. Flush joint This joint is best used when the wall is intended to be plastered or joints are to be hidden under paint.
Eaves overhang, shown here with a bracket system of modillions. The eaves are the edges of the roof which overhang the face of a wall and, normally, project beyond the side of a building. The eaves form an overhang to throw water clear of the walls and may be highly decorated as part of an architectural style, such as the Chinese dougong ...
Typically, a landscaping rake boasts a head measuring 30 to 38 inches or even broader, featuring steel tines set at a 90-degree angle to the handle. A stone rake is similar to a landscape rake, but with a narrower head of about 18 to 28 inches and is constructed from steel or aluminum. The head sits at a 90-degree angle to the handle.
Slipform stonemasonry is a method for making a reinforced concrete wall with stone facing in which stones and mortar are built up in courses within reusable slipforms. It is a cross between traditional mortared stone wall and a veneered stone wall. Short forms, up to 60 cm high, are placed on both sides of the wall to serve as a guide for the ...
Components on a concrete masonry unit and brick cavity wall. A cavity wall is composed of two masonry walls separated by an air space. The outer wall is made of brick and faces the outside of the building structure. [6] The inner wall may be constructed of masonry units such as concrete block, structural clay, brick or reinforced concrete. [6]
The Bison wall-frame construction system was a construction method used in tower block construction. It was launched in 1963 by Concrete Ltd who set up factories across the UK to pre-fabricate the parts it. It was not a frame structure as such, instead precast concrete panels formed the structure of high rise blocks.