Search results
Results From The WOW.Com Content Network
A variant of the metric perm is used in DIN Standard 53122, where permeance is also expressed in grams per square meter per day, but at a fixed, "standard" vapor-pressure difference of 17.918 mmHg. This unit is thus 17.918 times smaller than a metric perm, corresponding to about 0.084683 of a U.S. perm.
10 Pa Pressure increase per millimeter of a water column at Earth mean sea level [26] 10 Pa Pressure due to direct impact of a gentle breeze (~9 mph or 14 km/h) [27] [28] [29] 86 Pa Pressure from the weight of a U.S. penny lying flat [30] 10 2 Pa
Sweeping across the top of the measure with the back of a straight knife or the blade of a spatula is a common leveling method. Rounded Allowing a measure of an ingredient to pile up above the rim of the measuring device naturally, into a soft, rounded shape. Heaping / heaped The maximum amount of an ingredient which will stay on the measuring ...
The boiling point of water is the temperature at which the saturated vapor pressure equals the ambient pressure. Water supercooled below its normal freezing point has a higher vapor pressure than that of ice at the same temperature and is, thus, unstable. Calculations of the (saturation) vapor pressure of water are commonly used in meteorology.
Percent concentration does not refer to this quantity. This improper name persists, especially in elementary textbooks. In biology, the unit "%" is sometimes (incorrectly) used to denote mass concentration, also called mass/volume percentage.
Statistical methods such as root mean square (RMS) duly address the "total" idea in this respect. The newer name "full indicator movement" (FIM) ...
From defining the p 50 as the partial pressure at which the fractional saturation is 50%, we can deduce that it is in fact equal to the dissociation constant K. + = = For example, myoglobin's p 50 for O 2 is 130 pascals while the P 50 for adult hemoglobin is 3.5 kPa.
The equation based definition of hardness is the pressure applied over the contact area between the indenter and the material being tested. As a result hardness values are typically reported in units of pressure, although this is only a "true" pressure if the indenter and surface interface is perfectly flat. [citation needed]