Search results
Results From The WOW.Com Content Network
The limiting reagent (or limiting reactant or limiting agent) in a chemical reaction is a reactant that is totally consumed when the chemical reaction is completed. [ 1 ] [ 2 ] The amount of product formed is limited by this reagent, since the reaction cannot continue without it.
The simplest case refers to the formation of a strictly linear polymer by the reaction (usually by condensation) of two monomers in equimolar quantities. An example is the synthesis of nylon-6,6 whose formula is [−NH−(CH 2) 6 −NH−CO−(CH 2) 4 −CO−] n from one mole of hexamethylenediamine, H 2 N(CH 2) 6 NH 2, and one mole of adipic acid, HOOC−(CH 2) 4 −COOH.
To find the limiting reagent and the mass of HCl produced by the reaction, we change the above amounts by a factor of 90/324.41 and obtain the following amounts: 90.00 g FeCl 3, 28.37 g H 2 S, 57.67 g Fe 2 S 3, 60.69 g HCl. The limiting reactant (or reagent) is FeCl 3, since all 90.00 g of it is used up while only 28.37 g H 2 S are consumed.
The stoichiometry of a chemical reaction is based on chemical formulas and equations that provide the quantitative relation between the number of moles of various products and reactants, including yields. [8] Stoichiometric equations are used to determine the limiting reagent or reactant—the reactant that is completely consumed in a reaction ...
Conversion and its related terms yield and selectivity are important terms in chemical reaction engineering.They are described as ratios of how much of a reactant has reacted (X — conversion, normally between zero and one), how much of a desired product was formed (Y — yield, normally also between zero and one) and how much desired product was formed in ratio to the undesired product(s) (S ...
As an example, consider the gas-phase reaction NO 2 + CO → NO + CO 2.If this reaction occurred in a single step, its reaction rate (r) would be proportional to the rate of collisions between NO 2 and CO molecules: r = k[NO 2][CO], where k is the reaction rate constant, and square brackets indicate a molar concentration.
Here, a primary standard is typically a reagent which can be weighed easily, and which is so pure that its weight is truly representative of the number of moles of substance contained. Features of a primary standard include: High purity; Stability (low reactivity) Low hygroscopicity (to minimize weight changes due to humidity)
where [A] 0 is the amount, absorbance, or concentration of substrate initially present and [A] t is the amount, absorbance, or concentration of that reagent at time, t. Normalizing data to fractional conversion may be particularly helpful as it allows multiple reactions run with different absolute amounts or concentrations to be compared on the ...