Search results
Results From The WOW.Com Content Network
A pin chuck is a specialized chuck designed to hold small drills (less than 1 mm (0.039 in) in diameter) that could not be held securely in a normal drill chuck. The drill is inserted into the pin chuck and tightened; the pin chuck has a shaft which is then inserted into the larger drill chuck to hold the drill securely.
Drawbar force gauges are able to detect broken or weakening components of the drawbar clamping system, can give indications that the unit needs lubrication, detect gripper mis-adjustment, or demonstrate that the incorrect retention knob is being used for the machine. A retention knob is a device screwed into the narrow end of a tool holder ...
Several machine collets (top and centre) and a dismantled pin chuck (below). Generally, a collet chuck, [3] considered as a unit, consists of a tapered receiving sleeve (sometimes integral with the machine spindle), the collet proper (usually made of spring steel) which is inserted into the receiving sleeve, and (often) a cap that screws over the collet, clamping it via another taper.
Endorse this file for transfer by adding |human=<your username> to this Template. If this file is freely licensed, but otherwise unsuitable for Commons (e.g. out of Commons' scope , still copyrighted in the US), then replace this Template with {{ Do not move to Commons |reason=<Why it can't be moved>}}
It forms predetermined bends by clamping the workpiece between a matching top tool and bottom die. [2] Bending process A high-tonnage hydraulic press brake Liwei CNC 2000T 12M Heavy Duty model. Typically, two C-frames form the sides of the press brake, connected to a table at the bottom and on a movable beam at the top.
A vacuum table consists of a typically flat rigid surface with small holes to move air from under a workpiece, as to apply varying vacuum from between the desired workpiece and table to maintain a clamping force greater than that needed to machine a part, generally, in a mill, lathe, EDM (Electro-Discharge Machine), pantograph or any other ...
An HSK connection depends on a combination of axial clamping forces and taper-shank interference. All these forces are generated and controlled by the mating components' design parameters. The shank and spindle both must have precisely mating tapers and faces that are square to the taper's axis. There are several HSK clamping methods.
A hydraulic cylinder is the actuator or "motor" side of this system. The "generator" side of the hydraulic system is the hydraulic pump which delivers a fixed or regulated flow of oil to the hydraulic cylinder, to move the piston. There are three types of pump widely used: hydraulic hand pump, hydraulic air pump, and hydraulic electric pump.