Ad
related to: dependent suspension system for cars reviews and ratings and complaints
Search results
Results From The WOW.Com Content Network
This is the most common, widely used front suspension system in cars today. It is a very simple and effective design that uses a strut-type spring and shock absorber that work as a team that will pivot on a single ball joint. This system was popularized in British Fords in the 1950s, then adopted by BMW (1962) and Porsche (1963).
As such, push-rod suspension systems allow for much greater high-speed stability, much lower levels of body-roll, and a much lower centre of gravity for the vehicle. [7] For pull-rod suspension systems, the only difference is the orientation of the rocker arms. In a push-rod system, the rocker arms are placed at the highest point in the assembly.
Van Diemen RF01 Racing Car Suspension. Suspension is the system of tires, tire air, springs, shock absorbers and linkages that connects a vehicle to its wheels and allows relative motion between the two. [1] Suspension systems must support both road holding/handling and ride quality, [2] which are at odds with each other. The tuning of ...
An active suspension is a type of automotive suspension that uses an onboard control system to control the vertical movement of the vehicle's wheels and axles relative to the chassis or vehicle frame, rather than the conventional passive suspension that relies solely on large springs to maintain static support and dampen the vertical wheel movements caused by the road surface.
The driveshafts had now ceased to be a structural part of the suspension, so they could be fitted with constant-velocity joints that allowed their length to vary with suspension travel. This system with modifications has now been incorporated into the Jaguar XJ (X350) in 2003, Jaguar XK (X150) in 2006, Jaguar XF (X250) in 2007, revised Jaguar ...
A multi-link suspension is a type of independent vehicle suspension having three or more control links per wheel. [1] These arms do not have to be of equal length, and may be angled away from their "obvious" direction. It was first introduced in the late 1960s on the Mercedes-Benz C111 [2] and later on their W201 and W124 series. [3] [4]
A beam axle, rigid axle, or solid axle is a dependent suspension design in which a set of wheels is connected laterally by a single beam or shaft. Beam axles were once commonly used at the rear wheels of a vehicle, but historically, they have also been used as front axles in four-wheel-drive vehicles.
[7] 4WD variants of the Honda Fit and Honda HR-V subcompact SUV have been reported as using a de Dion style suspension; [8] however, these vehicles actually have a twist-beam rear suspension, with the cross beam element located even further forward (and thus even more like a trailing arm and less like the beam axle of a de Dion) than the 2WD ...