When.com Web Search

  1. Ads

    related to: glass suction clamps for metal

Search results

  1. Results From The WOW.Com Content Network
  2. Glass-to-metal seal - Wikipedia

    en.wikipedia.org/wiki/Glass-to-metal_seal

    Uranium glass used as lead-in seals in a vacuum capacitor. Glass-to-metal seals are a type of mechanical seal which joins glass and metal surfaces. They are very important elements in the construction of vacuum tubes, electric discharge tubes, incandescent light bulbs, glass-encapsulated semiconductor diodes, reed switches, glass windows in metal cases, and metal or ceramic packages of ...

  3. Glass mullion system - Wikipedia

    en.wikipedia.org/wiki/Glass_mullion_system

    Glass mullion system with vertical glass fins. Glass mullion system or glass fin system is a glazing system in which sheets of tempered glass are suspended from special clamps, stabilized by perpendicular stiffeners of tempered glass, and joined by a structural silicone sealant or by metal patch plates. [1]

  4. Automated patch clamp - Wikipedia

    en.wikipedia.org/wiki/Automated_patch_clamp

    This creates the gigaohm seal characteristic of a patch clamp recording. The traditional manual method to patch clamp using glass pipettes was developed by Erwin Neher and Bert Sakmann and required a highly skilled technician. The technician would position the glass pipette near a cell and apply the appropriate suction to create an electrical ...

  5. Büchner flask - Wikipedia

    en.wikipedia.org/wiki/Büchner_flask

    A Büchner flask, also known as a vacuum flask, [1] filter flask, suction flask, side-arm flask, or Bunsen flask, is a thick-walled Erlenmeyer flask with a short glass tube and hose barb protruding about an inch from its neck.

  6. Ground glass joint - Wikipedia

    en.wikipedia.org/wiki/Ground_glass_joint

    The ball tip is a hemisphere with a ground-glass surface on the outside, which fits inside of the socket, where the ground glass surface is on the inside. This type of joint separates freely and must be held together with a clamp. Ball-and-socket joints are labeled with a size code consisting of a number, a slash, and another number.

  7. Hose clamp - Wikipedia

    en.wikipedia.org/wiki/Hose_clamp

    The clamp is placed over the end of the hose or tube to be connected and when each ear is closed at the base of the ear with a special pincer tool, it permanently deforms, pulling the band, and causing the band to tighten around the hose. The size of clamp should be chosen such that the ear(s) are almost completely closed on installation.