When.com Web Search

  1. Ads

    related to: hydraulic oil cross reference guide 720 to 800 psi

Search results

  1. Results From The WOW.Com Content Network
  2. Orders of magnitude (pressure) - Wikipedia

    en.wikipedia.org/wiki/Orders_of_magnitude_(pressure)

    1.5 psi Pressure increase per meter of a water column [26] 10 kPa 1.5 psi Decrease in air pressure when going from Earth sea level to 1000 m elevation [citation needed] +13 kPa +1.9 psi High air pressure for human lung, measured for trumpet player making staccato high notes [48] < +16 kPa +2.3 psi

  3. Hydraulic fluid - Wikipedia

    en.wikipedia.org/wiki/Hydraulic_fluid

    Its bulk modulus at 1000 °F (538 °C) is 310,000 psi (2.14 GPa), higher than of a hydraulic oil at room temperature. Its lubricity is poor, so positive-displacement pumps are unsuitable and centrifugal pumps have to be used.

  4. Pound per square inch - Wikipedia

    en.wikipedia.org/wiki/Pound_per_square_inch

    The kilopound per square inch (ksi) is a scaled unit derived from psi, equivalent to a thousand psi (1000 lbf/in 2). ksi are not widely used for gas pressures. They are mostly used in materials science, where the tensile strength of a material is measured as a large number of psi. [4] The conversion in SI units is 1 ksi = 6.895 MPa, or 1 MPa ...

  5. Fire hose - Wikipedia

    en.wikipedia.org/wiki/Fire_hose

    It retains its round cross-section when it is not under pressure and is usually carried on a reel on the fire pumper, rather than being stored flat. Booster hose comes in 0.75 and 1.0 in (19 and 25 mm) nominal inside diameters and is designed to operate at pressures up to 800 psi (5,520 kPa). The standard length is 100 ft (30.48 m). [13]

  6. Hydraulic motor - Wikipedia

    en.wikipedia.org/wiki/Hydraulic_motor

    However, many hydraulic pumps cannot be used as hydraulic motors because they cannot be backdriven. Also, a hydraulic motor is usually designed for working pressure at both sides of the motor, whereas most hydraulic pumps rely on low pressure provided from the reservoir at the input side and would leak fluid when abused as a motor. [1]

  7. Hydraulic cylinder - Wikipedia

    en.wikipedia.org/wiki/Hydraulic_cylinder

    A hydraulic cylinder is the actuator or "motor" side of this system. The "generator" side of the hydraulic system is the hydraulic pump which delivers a fixed or regulated flow of oil to the hydraulic cylinder, to move the piston. There are three types of pump widely used: hydraulic hand pump, hydraulic air pump, and hydraulic electric pump.

  8. Dynamic pressure - Wikipedia

    en.wikipedia.org/wiki/Dynamic_pressure

    In fluid dynamics, dynamic pressure (denoted by q or Q and sometimes called velocity pressure) is the quantity defined by: [1] = where (in SI units): . q is the dynamic pressure in pascals (i.e., N/m 2,

  9. Separator (oil production) - Wikipedia

    en.wikipedia.org/wiki/Separator_(oil_production)

    Oil and gas separators can have three general configurations: vertical, horizontal, and spherical.Vertical separators can vary in size from 10 or 12 inches in diameter and 4 to 5 feet seam to seam (S to S) up to 10 or 12 feet in diameter and 15 to 25 feet S to S. Horizontal separators may vary in size from 10 or 12 inches in diameter and 4 to 5 feet S to S up to 15 to 16 feet in diameter and ...

  1. Ad

    related to: hydraulic oil cross reference guide 720 to 800 psi