Ads
related to: 4l60e transmission shifting problems explain 3
Search results
Results From The WOW.Com Content Network
The police package (9C1) B-body cars featured a First Gear Block Out (FGBO) Plate on the transmission housing to prevent drivetrain damage. The shift point for first to second gear is about 43 MPH (69 km/h) while second to third gear shift point is about 83 MPH (134 km/h) assuming a 3.08:1 differential and a 5,500 RPM engine speed limit.
For 1991 GM introduced the 4T60-E which was a 4T60 with electronic controls, first seen on the new Buick Park Avenue.One benefit was that the cruise control was integrated into the gearbox' electronic control module, improving the ability to maintain a set speed while avoiding needless shifting, thus lowering fuel consumption and noise levels. [1]
The fourth-generation Chevrolet Camaro is a pony car that was produced by American automobile manufacturer General Motors for the 1993 through 2002 model years. It was introduced on an updated F-body platform but retained the same characteristic since the first-generation's introduction back in 1967: two doors, coupe or convertible bodystyles, rear-wheel drive, and a choice of 6-cylinder and ...
In 1996, GM introduced a redesigned 4L60E transmission case that incorporated a bolt-on bellhousing and a six-bolt tail housing. This two-piece case style was first seen in 1996 and up model S-10 Blazer, S-10 pickup, GMC Jimmy, and GMC Sonoma with the 4.3 L engine. The majority of 1998 and later applications of the 4L60E were two-piece cases (i ...
A transmission control unit (TCU), also known as a transmission control module (TCM), or a gearbox control unit (GCU), is a type of automotive ECU that is used to control electronic automatic transmissions. Similar systems are used in conjunction with various semi-automatic transmissions, purely for clutch automation and actuation.
For 1993, the Fleetwood carried over the 185hp 5.7L V8 used by the 1990–1992 Cadillac Brougham, paired with a four-speed 4L60 automatic transmission. For 1994, GM upgraded its full-size powertrains, with the D-body and B-body cars receiving a 260hp 5.7L LT1 V8, paired with an electronically-controlled 4L60E four-speed automatic.
When it is switched on, an automatic transmission can shift into overdrive mode after a certain speed is reached (usually 70+ km/h [40-45 mph or more] depending on the load). When it is off, the automatic transmission shifting is limited to the lower gears. Overdrive should usually be selected when the average speed is above 70 km/h (40-45 mph).
The 1941 Chrysler M4 Vacamatic transmission was a two-speed manual transmission with an integral underdrive unit, a traditional manual clutch, and a fluid coupling between the engine and the clutch. [51] [52] [53] The two-speed transmission had "high" and "low" ranges, and the clutch was used when the driver wanted to switch between ranges. For ...