When.com Web Search

  1. Ads

    related to: transfer case and transmission difference chart

Search results

  1. Results From The WOW.Com Content Network
  2. AMC and Jeep transmissions - Wikipedia

    en.wikipedia.org/wiki/AMC_and_Jeep_transmissions

    The Dana 300 part-time gear-driven transfer case. [2] That uses a round bolt pattern and has a nearly flat oil pan. It is a heavy-duty, gear-driven transfer case with a 23-spline input shaft. The case is cast iron but the tail housing is aluminum. The ID number C300-15 is stamped on the case.

  3. Transfer case - Wikipedia

    en.wikipedia.org/wiki/Transfer_case

    A divorced or independent transfer case is completely separate from the transmission. It is located further down the driveline than a married transfer case and connected to the transmission output shaft by a short driveshaft. Independent transfer cases are used on very long wheelbase vehicles, such as commercial trucks or military trucks.

  4. Toyota R transmission - Wikipedia

    en.wikipedia.org/wiki/Toyota_R_transmission

    A 2WD 5 speed transmission found in most light duty Toyota Dyna trucks, this transmission has a drum brake on the rear and steel housings. These transmissions can be used to give a significantly lower first, and a slightly higher overdrive (5th: 0.695:1) when fitted to an R151 4WD gearbox. [4] First Gear: 5.147:1; Second Gear: 2.74:1; Third ...

  5. List of GM transmissions - Wikipedia

    en.wikipedia.org/wiki/List_of_GM_transmissions

    Saginaw M26/27 transmission — 3 and 4-speed longitudinal light duty (less than 300 hp) wide ratio manual transmission made by GM at their Saginaw, Michigan factory; Muncie M62/M64 — 3-speed longitudinal transmission made by GM; Muncie SM318 transmission — 3-speed transmission used from 1954 through 1969 in both passenger car and truck ...

  6. List of Ford bellhousing patterns - Wikipedia

    en.wikipedia.org/wiki/List_of_Ford_bellhousing...

    1.8, 2.0/2.3 had the same bellhousings bolt patterns with differences from year to year to be wary of. The Mazda transmission 5M** does not "directly replace" the Mitsubishi transmissions as there are shifter spacing differences in the floorboard. The Mitsubishi transmission was made to fit Mustang IIs and was shoehorned into the early Rangers.

  7. Toyota A transmission - Wikipedia

    en.wikipedia.org/wiki/Toyota_A_transmission

    The detachable bell housing, which attaches the main transmission case to the engine, has an engine-specific bolt pattern, which appears on its upper surface as cast-in letters. "J" indicates the straight-6 1/2-JZ engine, "U" the V8 UZ engine. Applications (calendar years) 1985–1995 Toyota Pick-Up 3.0L; 1986–1993 Toyota Supra (MA70)