Search results
Results From The WOW.Com Content Network
The commonly used standard cell has a width of 1 cm [clarify], and thus for very pure water in equilibrium with air would have a resistance of about 10 6 ohms, known as a megohm. Ultra-pure water could achieve 18 megohms or more. Thus in the past, megohm-cm was used, sometimes abbreviated to "megohm".
The siemens (symbol: S) is the unit of electric conductance, electric susceptance, and electric admittance in the International System of Units (SI). Conductance, susceptance, and admittance are the reciprocals of resistance, reactance, and impedance respectively; hence one siemens is equal to the reciprocal of one ohm (Ω −1) and is also referred to as the mho.
where is the length of the conductor, measured in metres (m), A is the cross-sectional area of the conductor measured in square metres (m 2), σ is the electrical conductivity measured in siemens per meter (S·m −1), and ρ is the electrical resistivity (also called specific electrical resistance) of the material, measured in ohm-metres (Ω ...
Electrical conductivity can be expressed using a number of different units but the international standard is EC, and the unit of measurement is usually milliSiemens or microSiemens. The difference between these two units of measurement is the placement of the decimal point, so 1 milliSiemens is equal to 1000 microSiemens.
Admittance Y, measured in siemens, is defined as the inverse of impedance Z, measured in ohms: Resistance is a measure of the opposition of a circuit to the flow of a steady current, while impedance takes into account not only the resistance but also dynamic effects (known as reactance). Likewise, admittance is not only a measure of the ease ...
Transresistance (for transfer resistance), also infrequently referred to as mutual resistance, is the dual of transconductance. It refers to the ratio between a change of the voltage at two output points and a related change of current through two input points, and is denotated as r m:
The Jiffy is the amount of time light takes to travel one femtometre (about the diameter of a nucleon). The Planck time is the time that light takes to travel one Planck length. The TU (for time unit) is a unit of time defined as 1024 μs for use in engineering. The svedberg is a time unit used for sedimentation rates (usually
Conversion of per-unit quantities to volts, ohms, or amperes requires a knowledge of the base that the per-unit quantities were referenced to. The per-unit system is used in power flow, short circuit evaluation, motor starting studies etc. The main idea of a per unit system is to absorb large differences in absolute values into base relationships.